McMaster-Carr logo
    Filter by
    System of Measurement
    Material
    Body Shape
    Overall Length
    Taper Length
    End Shape
    Certification
    USMCA Qualifying
    Performance
    Body Texture
    Number of Tapered Ends
    Sold As
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    9 Products

    Nonsparking Alignment Pins

    Image of Product. Front orientation. Contains Annotated. Alignment Pins. Nonsparking Alignment Pins.
    Made from aluminum bronze that is Factory Mutual approved, these nonmagnetic, corrosion-resistant pins inhibit sparking. They satisfy OSHA requirements for nonsparking tools for locations where flammable vapors and combustible residues are present. Nonsparking tools are not, however, classified as antistatic because they do conduct electricity. Use alignment pins to align structural components such as I-beams and angle irons for bolting, riveting, and welding.
    Note: Do not use these tools in direct contact with acetylene.
    Body
    Point
    Dia.
    Taper
    Lg.
    Dia.
    Overall
    Lg.
    Shape
    Texture
    Each
    Aluminum Bronze
    1/4"3 3/4"1/2"6"RoundSmooth0000000000000
    9/32"3 3/4"11/16"6"RoundSmooth000000000000
    5/16"5"13/16"8"RoundSmooth000000000000
    7/16"6"15/16"10"RoundSmooth000000000000
    1/2"6"1 1/8"10"RoundSmooth000000000000
     

    Double-Tapered-End Nonsparking Alignment Pins

    Image of Product. Front orientation. Alignment Pins. Double-Tapered-End Nonsparking Alignment Pins.
    When one end of these pins wears out, use the other one. Made from aluminum bronze that is Factory Mutual approved, these nonmagnetic, corrosion-resistant pins inhibit sparking. They satisfy OSHA requirements for nonsparking tools for locations where flammable vapors and combustible residues are present. Nonsparking tools are not, however, classified as antistatic because they do conduct electricity. Use alignment pins to align structural components such as I-beams and angle irons for bolting, riveting, and welding.
    Note: Do not use these tools in direct contact with acetylene.
    Body
    Point
    Dia.
    Dia.
    Overall
    Lg.
    Shape
    Texture
    Each
    Aluminum Bronze
    3/16"11/16"8"RoundSmooth0000000000000
    5/16"13/16"8"RoundSmooth000000000000
    7/16"15/16"8"RoundSmooth000000000000
    11/16"1 3/16"8"RoundSmooth000000000000
     
    back to top