Three cutting edges instead of the typical two enable these bits to drill holes with a smoother finish than other bits. Made of solid carbide for the highest accuracy and longest tool life, they are harder, stronger, and more wear resistant than high-speed steel, cobalt steel, and carbide-tipped bits. They retain a sharp, hard edge at high temperatures for the best performance on hard and abrasive material. These bits require rigid toolholding to prevent breakage and should not be used in hand-held drilling. All are jobbers’ length so they have the rigidity and length required for most applications. A split point keeps the bit centered without a pilot hole.

For technical drawings and 3-D models, click on a part number.

The shank has a smaller diameter than the tip, allowing you to drill large holes with machines that have small-capacity chucks. Also known as Silver and Deming bits, they have a 1/2” diameter shank.

Drill bits with flats on shank have three flat sides to prevent the bit from slipping in the drill chuck.

Drill bits with a split point keep centered without a pilot hole.

For technical drawings and 3-D models, click on a part number.

Install the Morse taper shank directly into the tapered spindle on machines such as drill presses and lathes.

For technical drawings and 3-D models, click on a part number.

The sharp point allows for gradual penetration to reduce friction and eliminate cracking and chipping when drilling in plastic. These bits are jobbers' length and have the rigidity and length required for most applications.

For technical drawings and 3-D models, click on a part number.

Unlike traditional wire-installing drill bits, you do not need to strip the end of the wire when using one of these bits. After drilling, insert the wire into the bit's hollow shaft and pull through the drilled hole. Also known as bell hanger bits.

For technical drawings and 3-D models, click on a part number.