Use these end mills for general purpose milling in most material, such as aluminum, brass, bronze, iron, and steel. They have a square end for milling square slots, pockets, and edges.

End mills with fewer flutes provide better chip clearance for high-volume, high-speed plunge, slotting, and roughing cuts; end mills with more flutes provide a finer finish and operate with less vibration when run at high speeds.

With a higher helix angle than standard high-speed steel end mills, these clear more chips and generate less heat, making them good for milling soft material, such as aluminum, brass and bronze. They are center cutting for making plunge cuts into surfaces and have a square-end cut style for milling square slots, pockets, and edges.

Also known as subland drill bits, these last longer than standard counterbore drill bits because the diameter stays the same after sharpening. They drill and counterbore at the same time. After drilling and counterboring, tap the hole and install your fastener.

Drill and thread holes in a single fluid step that’s 15 times faster than by hand. Made with an oversized shank and hardened high-speed steel, these drill taps are built to handle the high torque of your impact wrench to cut material quickly. A built-in pilot starts the hole while the taper chamfer gradually engages material for clean, accurate threads. Your wrench’s rapid hammering helps break and clear chips as you cut, so you don’t need to pause and reverse. This also means these drill taps are less likely to jam on chips and snap. They’re a great choice for quickly preparing threaded through holes in thin materials.

You’ll need a VersaDrive chuck (sold separately) to install these drill taps into your impact wrench. You can also get chucks for impact drivers (sold separately).

Serrations along the cutting edge act as chip breakers, so these end mills can remove large amounts of material at high speeds. They are high-speed steel for general purpose milling in most material, such as aluminum, brass, bronze, iron, and steel. Their square end makes them good for milling square slots and edges.

End mills with fewer flutes provide better chip clearance for high-volume, high-speed plunge, slotting, and roughing cuts; end mills with more flutes provide a finer finish and operate with less vibration when run at high speeds.

With better heat and wear resistance than high-speed steel, these cobalt steel end mills can run at higher speeds and provide better performance on hard material, such as iron, hardened steel, titanium, and tool steel. They have a square end for milling square slots, pockets, and edges.

End mills with fewer flutes provide better chip clearance for high-volume, high-speed plunge, slotting, and roughing cuts; end mills with more flutes provide a finer finish and operate with less vibration when run at high speeds.

To set torque, remove the snap ring and locking plate and adjust the nut. When the torque setting is reached, these adapters click and release. These tools let you accurately measure or limit the torque you apply to prevent overtightening and damaging fasteners.