Stick these flexible heat sheets to container surfaces to warm contents without direct contact.

For more durability than other adhesive-mount heaters, a thick layer of fiberglass-reinforced silicone rubber encases the heating element.

FM approved, these heat sheets are safe for use in areas with infrequent exposure, such as from a spill or a ventilation system failure, to flammable gases, liquids, and dust.

Nonstandard-size containers are no problem—use the hook-and-loop closure to adjust these heaters to fit a range of diameters.

Also known as heat blankets, these heaters completely surround containers for fast heating and increased heat retention in unheated and drafty areas.

Extend the shelf life of your diesel exhaust fluid (DEF) while storing it in cold places.

To prevent hot spots that can damage heat-sensitive materials such as adhesives, sealants, and food, these heaters warm the air around containers without touching them.

Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

Wrap the flexible heating element around small-diameter pipes and tubes or pack it into tight spaces.

With a cable that supplies the same wattage along the entire length, these heaters remain consistent regardless of the surrounding temperature. All require a temperature switch or controller to regulate heat output.

Also known as self-regulating heat cable, these heaters automatically adjust heat output at different points along their length to account for differences in environmental temperature.

Keep the liquid inside your hose from freezing, maintain your liquid’s viscosity, and prevent condensation in chilly environments.

Form these flexible heaters into any shape to mount them through brackets, collars, and holes. They are also known as tubular heaters.

Form these heaters into any shape and install them through container walls with the attached bulkhead fittings.

Often used with extrusion, injection, and blow-molding machinery, these heaters clamp around nozzles to keep material warm for consistent discharge.