These sets come with three punches for use with a variety of hole sizes. Insert one into an existing hole and twist the handle to open the end of the punch. The point automatically centers once the punch has fit the hole size.

Also known as transfer screws, the punches in these sets can be used in any threaded hole to transfer the hole location. Use the handle to screw a punch into a hole.

Also known as transfer screws, these punches have a uniform shoulder height so you can quickly transfer multiple hole locations at once.

Also known as center punches, the tools in these sets mark hole centers in metal and other materials.

Minimize damage to your work surfaces with these brass punches, which are softer than steel punches.

The rounded tip of these punches fits into the open ends of hollow and spring pins to protect them from damage during removal.

Contains pin-loosening, pin-removal, and center-marking punches.

These brass tools reduce marring on metal surfaces because they're softer than steel punches.

Attach two punch heads to the handle at the same time to punch a gasket or washer in a single strike.

Sets include common ID and OD sizes to create gaskets and washers in two strikes.

Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

The driver supplies eight tons of force to the hole punches in this set to make straight punches.

The included hydraulic driver allows you to punch conduit up to size 2.