The nonstick surface is good for liquids that tend to clog, such as instant-bonding adhesives.

The needles in these sets connect to adhesive cartridges, grease guns, and other dispensers with threaded connections.

Often used to spread adhesives when attached to syringes and dispensers with a luer lock connection.

A curved plastic tip fits into bearing seals, narrow holes in housings, and around small parts in 3D printers and other machinery. Use these syringes to control the direction of flow so you don't make a mess.

Trim the opening size to the diameter you need.

Use these syringes with an air-powered dispenser to make repetitive dispensing easier on your hands.

The ergonomic design helps reduce fatigue when dispensing one-part adhesives, sealants, and fluids.

Often used in chromatography applications, these filters attach to any syringe with a luer lock connection to filter out contaminants both when drawing in and dispensing.

A unique valve on these pens and bottles releases a precise amount of liquid without flooding the tip and splattering.

With their heavy duty spring-action trigger, these guns easily apply thick liquids such as adhesives.

Dispense two-part adhesives with compressed air. Use these guns only with 3M dual cartridges.

Use these guns to dispense two-part adhesives. Do not use them with 3M dual cartridges.

Use these plungers with a dispensing gun for adhesives in dual cartridges.

Fill these cartridges with the two-part adhesive of your choice.

Attach these nozzles to a cartridge for controlled dispensing.

Guns are powered with compressed air for controlled dispensing on small and large jobs alike.

Thread these holders onto a gun to hold an adhesive cartridge.

Similar to a caulk gun, these guns are good for small jobs.

Swap out worn or broken parts for your 3M hot-melt glue gun.

Dispense 3M hot-melt adhesives with these guns.

Choose from cone tips, L-tips, and T-tips.

Squeeze out bubbles with these rollers - thin ridges allow air to escape.

Melt and dispense hot-melt glue sticks for sealing and assembling.

Don't be tethered by a cord—take these guns where they're needed.

Use these guns in heat-sensitive applications and on delicate materials. They have a temperature setting of 250° F.

Spread adhesives with these trowels.

Use these guns for easy dispensing of 3M glue-on-a-roll.

Screw the gun onto a bottle of Loctite® threadlocker or retaining compound, then set the dial to control the amount being dispensed.

Keep cups and sticks on hand for mixing two-part adhesives.

Use these primers with structural epoxies, acrylics, and urethanes to promote bonding to EPDM rubber, polyolefin, and thermoplastic elastomers.

Improve instant-bond adhesive performance on hard-to-bond materials.

These flexible extensions add length and bend 180° to get into hard-to-reach areas.

Let compressed air do the work for you when dispensing sealants from cartridges.

Adjust air-flow for precise control and smooth material flow—these guns have a built-in pressure regulator with a control knob.

Dispense sealants from cartridges with ease and control.

Immerse the nozzle in the sealant and pull back the rod to fill.

Apply epoxies, urethanes, and other thick solvent-based coatings with the short and stiff natural bristles on these brushes.

Keep roller covers secure with the gripping tabs on these frames.

Use these frames to cover large, flat surfaces quickly.