Remove adhesives and residue from a broad range of surfaces. These removers are effective on common adhesives, such as those found on labels and tape.

Remove silicone, foam sealants, caulk, wet or dry latex-based foams, and construction adhesives. Safe for use on plastics, fiberglass, and most metals.

Coat electronics for durability in tough conditions while blocking EMI/RFI signals. Made of epoxy mixed with silver-coated copper, these coatings are stronger than acrylic plastic EMI/RFI coatings. They are rigid enough to withstand the wear of access panels and industrial cabinets. You can also use them in engine compartments because they resist damage from high temperatures and chemicals. Also known as conductive paint, they shield your parts from interference that could cause circuit malfunction and data loss. Mix the two parts of these compounds together and paint them on components.

Keep these pens on standby to touch up sticky messes around your facility. Their fine tip lets you precisely target residue, such as tape, glue, or gum, without getting excess spray on surrounding surfaces. A spill-proof barrel dispenses fluid only when pressed, so they won’t leak in your toolbox or pockets.

Remove residue left by tape, labels, and other adhesives with a swipe. These disposable, saturated wipes eliminate the mess of pouring and spraying adhesive removers. They’re safe for most hard and soft surfaces and have a mild citrus odor. However, they leave an oily residue and should be rinsed with soap and water after use.

When super glue becomes a super mess. These removers clean unwanted beads or drops of instant-bond adhesives, even if they’re already cured. Or you can use them to soak bonded parts to separate them. Keep in mind, they can damage paint, coatings, and finishes, so use them with care.

Spray on all types of metal molds to eliminate moisture, dirt, oils, and release agents. The solvent-based formula cuts through stubborn buildup—including adhesives, tar, and wax—without damaging mold surfaces. Clean molds maintain precise part dimensions and reliable release between cycles. This cleaner is compatible with a wide range of metals and plastics, so you can use one product across different mold types.

Cut through the strongest of structural adhesives before they fully cure. These removers clean unwanted drips or spills from epoxy and urethane-based adhesives such as Gorilla Glue. They can damage paint, coatings, and finishes, so use them with care.

Less aggressive than our standard epoxy removers, these solvent-based wipes remove uncured epoxy adhesives and solder paste. They are often used to wipe excess epoxy and paste off printed circuit boards and other electronic components.