These switches use DC input voltage and produce PNP or NPN signal output. They're often used with programmable logic controllers (PLCs).

Use these switches to sense metallic objects in environments containing flammable gases and combustible dust. ATEX and IECEx certified to protect against explosion, they produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

With a smaller diameter and shorter length than standard sized switches, these fit in the most space-constrained areas.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

Detect aluminum cans, copper tubing, and other metal items that don’t contain iron.

Turn the face on these switches to sense metallic objects from the front, sides, top, or bottom.

Check the position of your torch or workpiece for accuracy during robotic welding.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

Switches accept both AC and DC input voltage.

These switches have a longer sensing distance compared to other proximity switches with the same diameter.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

These switches detect magnetic objects—or objects with a magnet attached—through non-magnetic walls.

Also known as pico connectors, these connectors are often used with 8 mm and smaller proximity switches and photoelectric switches.