We will reply to your message within an hour.
Made with fiberglass for durability and abrasion resistance, this tape also withstands high temperatures.
Apply this liquid for a skin-tight protective coating that insulates and resists moisture, acids, and corrosion.
No need for adhesive—this tape fuses to itself for a permanent seal and stretches to fit virtually any form. Also known as cold shrink tape.
At only 0.0025" thick, this tape combines conformability with durability and abrasion resistance.
This chemical-resistant tape has adhesive on both sides.
Use this tape to modify printed circuit boards, shield components, and prototype wiring-board layout and design.
More conformable than copper foil electrical tape, this tape bonds to textured electronic housings, round cables, and other curved and irregular surfaces. Since it doesn’t leave gaps, it’s a great shield against electromagnetic interference (EMI).
Made of polyester fabric with a copper/nickel filler, this tape is highly conductive throughout, including the adhesive.
This polyester tape has a woven mesh edge that conducts electricity. Use it to shield cables and electronic components from EMI (electromagnetic interference).
Tested to meet ASTM E595, a standard used by NASA, this tape gives off almost no volatile emissions that could damage sensitive electronics, even in a vacuum. It’s more conformable than copper tape, so you can cover textured housings and round cables without leaving gaps for electromagnetic interference (EMI) to get in.
Twice as thick as our standard antistatic electrical tape, this tape is made of abrasion-resistant aramid and antistatic PTFE.
A coating on this polyimide tape minimizes ESD (electrostatic discharge) when unwound from the roll and also during removal.
Quickly conduct heat away from electronic components. Kapton® polyimide gives this tape excellent electrical isolation.
Use this tape to attach components to heat sinks and metal chassis walls in place of screws and other mechanical fasteners. It conducts heat away from sensitive electronics.
Also known as skived tape, this low-friction tape stretches to conform to irregular surfaces.
Our most slippery tape, the slick surface allows items to glide smoothly over it.
This tape provides a slick surface along with excellent resistance to electrical current.
Low-Friction Tape Shapes Made with Teflon® PTFE.
A strong, thick layer of Teflon® PTFE makes this tape tougher than standard Low-Friction Tape Made with Teflon® PTFE.
Highly resistant to impact, tearing, and corrosive chemicals, use FEP tape to line chutes and hoppers and to cover shelves in laboratories.
PEEK offers the best wear and abrasion resistance of our low-friction tapes. Use it for wire wraps and sliding bearing surfaces.
Use this tape to wrap and splice cables or to mask components while soldering.
Use these convenient cut shapes to mask holes, fastener heads, and small areas while soldering.
At half the thickness of our other masking tape for electronics, this polyimide tape conforms easily to components.
Seal out light to mask LEDs and prevent backlight bleed on LCD monitors with this opaque polyester tape.