Straighten out warped or sagging doors with the turn of a screw. The pin in these hinges has a threaded end for height adjustments. Tighten the set screw to keep it in position. Hinges mount to the surface of doors and frames.

No need to measure or drill new holes—these hinges will match your existing door and frame. Their screw holes are in a standardized, half-moon pattern that’s identical across manufacturers. Fit the hinge leaves into a cutout (mortise) for flush mounting.

Make unauthorized access nearly impossible. These hinges keep the leaves locked together, even if the pin is removed or broken. When the door is closed, the security stud engages so the door can't be lifted off. The pin is accessible only when the door is open. To remove it, loosen the set screw and the pull out the pin from the bottom of the hinge. For added security, hinges mount with tamper-resistant Torx screws, which require a special tool to remove. They work with or without a door closer.

The most widely used cabinet hinges are commonly found in workstations, breakrooms, and storage areas. Mount the door leaf in a round cutout (mortise) and the frame leaf to the cabinet wall. You can adjust them three ways to perfectly align doors. Also known as cup hinges and European hinges.

The hole pattern will match your door and the spring will swing it closed behind you. No need to measure and drill holes, these hinges have a standard half-moon pattern that’s identical across manufacturers. Fit the leaves into cutouts (mortises) to mount them flush with door and frame edges.

Maximize the width of doorways to make room for carts, large equipment, and furniture. These hinges fold open to shift the hinge pin and door completely out of the opening. Fit the hinge leaves into cutouts (mortises) for flush mounting on doors and frames.

Remove entry doors to clean, make repairs, or widen the opening to get equipment through. The pin is attached to the frame leaf for lifting off doors without removing the pin or screws. These hinges have a standard half-moon hole pattern that’s identical across manufacturers, so they’ll match your door and frame. Fit the leaves into cutouts (mortises) for flush mounting.

Keep busy doors swinging smoothly and quietly without the mess of oiling them. These hinges have enclosed self-lubricating bearings for reduced friction and long life. Their screw holes are in a standardized half-moon pattern to match your existing door and frame. Fit the hinge leaves into cutouts (mortises) for flush mounting. These hinges work with or without a door closer.

Work around worn-out holes with hinges that have a different pattern than the standard half-moon. A spring inside these hinges swings doors closed behind you. Fit the leaves into cutouts (mortises) to mount hinges flush with door and frame edges.