McMaster-Carr logo
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    2 Products

    T-Slot Nuts

    Image of Product. Front orientation. Contains Annotated. T-Slot Nuts.
    Slide into T-slot tracks on machine tool tables to secure clamps and workpieces. These nuts are often paired with setup studs for adjustable fixtures.
    Metric
    Black-Oxide Steel—Create a finished look with a dark, matte coating. These nuts offer minimal corrosion resistance, so they're best for dry environments.
    Fully Threaded—Fully threaded nuts allow a stud to extend beyond the bottom of the nut.
    DIN 508—Nuts meet DIN dimensional and material requirements. Slide them into DIN 650 T-slots.
    Base,
    mm
    Fully Threaded
    For Slot
    Wd., mm
    Thread
    Size
    Lg.
    Wd.
    Ht.
    Overall
    Ht., mm
    Specs.
    Met
    Each
    Black-Oxide Steel
    54M48 × 5 mm85853470DIN 5080000000000000000
     

    Seismic Stay-Put Swivel Leveling Mounts with Threaded Stud

    Image of Product. Front orientation. Leveling Mounts. Seismic Stay-Put Swivel Leveling Mounts with Threaded Stud, With Cushion.

    With Cushion

    Subjected to rigorous stress tests, these mounts withstand movement in every direction to minimize damage during an earthquake. After leveling your machine, bolt the mount to the floor and tighten the locking nut onto the base for added stability. The ball-and-socket joint in the base swivels to compensate for slightly sloped and pitted floors. For mounting versatility, you can install these mounts in either threaded holes or unthreaded through holes at the bottom of equipment.
    304 Stainless Steel Base—The choice for most wet locations, these mounts can withstand repeated washdowns without corroding. However, they won't hold up to cleaning solutions that contain harsh chemicals like 316 stainless steel can.
    Rubber Cushion—A cushion under the base protects floors from scrapes and gouges.
    With Rubber Cushion
    Mounting Holes
    Cap. per
    Mount, lb.
    Thread
    Size
    Thread
    Lg.
    No.
    of
    Fasteners
    Included
    Dia.
    Ctr.-to-Ctr.
    Lg.
    Swivel Range
    of Motion
    Base
    Dia.
    Specs.
    Met
    Load
    Pull
    Overall
    Ht.
    Cushion
    Material
    Each
    304 Stainless Steel Base and Stud
    M48 × 5 mm9 1/8"3No17/32"4 3/32"10°5 7/8"NZS 421931,4706,29013 1/2"Buna-N
    		000000000000000
     
    back to top