Optimized for use on steel, these inserts can run at higher cutting speeds and will last longer than inserts for multiple materials. Install inserts into a matching holder.

Inserts with a larger nose angle and tip radius remove more material with each pass but cut less precisely than smaller inserts. Select the insert with the largest nose angle and tip radius that will turn your workpiece to the desired shape.

Negative-rake inserts are the first choice for most turning applications. With strong cutting edges on two faces, they last longer than comparable positive-rake inserts. When all the edges on one face are worn, flip the insert over.

After choosing nose angle and rake type, consider roughing inserts for removing material quickly when surface finish isn’t a concern. Medium inserts remove a moderate amount of material for a semi-smooth surface finish. Use finishing inserts at the end of your turning process to remove minimal material for a smooth surface finish.

Inserts for semi-interrupted cutting conditions are the most commonly used, often to machine imperfectly round workpieces, such as shafts with a keyway.

Inserts sold individually come packed in a clear plastic case to protect cutting edges during shipment. Inserts sold in packs come factory sealed from the manufacturer for maximum traceability.

Heat resistant and shaped for turning stainless steel specifically, they’ll last longer than inserts for multiple materials. Install inserts into a matching holder.

Inserts with a larger nose angle and tip radius remove more material with each pass but cut less precisely than smaller inserts. Select the insert with the largest nose angle and tip radius that will turn your workpiece to the desired shape.

Negative-rake inserts are the first choice for most turning applications. With strong cutting edges on two faces, they last longer than comparable positive-rake inserts. When all the edges on one face are worn, flip the insert over.

After choosing nose angle and rake type, consider roughing inserts for removing material quickly when surface finish isn’t a concern. Medium inserts remove a moderate amount of material for a semi-smooth surface finish. Use finishing inserts at the end of your turning process to remove minimal material for a smooth surface finish.

Inserts for semi-interrupted cutting conditions are the most commonly used, often to machine imperfectly round workpieces, such as shafts with a keyway.

Inserts sold individually come packed in a clear plastic case to protect cutting edges during shipment. Inserts sold in packs come factory sealed from the manufacturer for maximum traceability.