Install and service setups for two, three, and five wires, then reuse these connectors later. They pop on and off wire with the flip of a clamp to save time over crimping. Choose them for setups that change often, such as prototypes and testing. They even have test sockets to safely test voltage after installation. The assortments include DIN-rail adapters so you can snap connectors into a control panel.

Seal out dust and moisture to protect splices, terminals, and other electrical connectors. These covers are lined with a sticky gel that encapsulates the electrical connector. The seal created by the gel helps them meet IP08 standards—use them in junction boxes and outlets exposed to high humidity, rain, and splashing water. Unlike potting compounds, you don't need to mix or pour the gel before you install these covers.

If you have to expand or repair a circuit, you can open these covers and use the wires again. However, once you open the cover and remove the gel, you’ll need a new electrical connector and cover.