Customize the bore of these collars to precisely fit your shaft.

Installing and removing a collar is as easy as pushing down and lifting up a clamp lever.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Two knurled sides provide micrometer-like movement for precise width adjustments.

Formed to offset the weight of the clamping screw, these collars won't wobble or vibrate when shafts are spinning—even at high speeds.

An embedded sleeve squeezes the shaft as you tighten the clamping screws, allowing these collars to handle up to three times the thrust load of standard collars.

Made of chemical-resistant nylon, these collars are suitable for washdown applications.

Make quick adjustments to these shaft collars with a lever on the side.

Customize the bore of these collars to precisely fit your shaft.

Use a wrench to rotate your drive shaft without marring or gouging the shaft.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Offering the benefits of a two-piece collar in a one-piece design, these collars swing open for positioning then close anywhere on your shaft.

Mount these collars flush against each other or attach components to either side—the round body has flattened ends with tapped holes.

These collars have two different sides—one locks down like a standard clamping shaft collar; the other has a flush face that you can machine to add slots, holes, and grooves to match your special setups.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Slide these one-piece collars onto the end of your shaft to create an end-stop for linear components.

Install these two-piece collars square shafts.

To install, thread these one-piece collars onto the end of your shaft.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Build your own system for hanging doors and curtains in marine environments. The track is anodized aluminum and the hangers are 316 stainless steel for corrosion resistance. Combine track, hangers, joints, and accessories for a complete system.

Curved and straight track pieces allow you to create a wide variety of layouts for doors, curtains, and strip doors.