Pivot your tool trays, control boxes, and other equipment in and out of reach. These arms have hinged connections at each joint that move smoothly yet resist drift once in place. You can configure them to support loads up to 100 lbs.—more than any of our other positioning arms. Unlike office-grade arms, these arms have a welded steel construction and precision fit joints to resist wear under heavy use.

Ready-to-use arms come with all you need to get started. You can also build a custom arm by combining bases, poles, connectors, mounting attachments, and more. The component with the lowest load capacity determines the capacity of the assembled arm.

Hang your HMI and swivel it around to save floor space and comfortably access touch screens, buttons, and other operating equipment. These suspension arms have already-drilled mounting holes that match our steel enclosures for positioning arms. Route wire from your HMI components to a machine through a hole that runs through the entire arm. To prevent them from swinging too far and hitting people and equipment, locking pins let you restrict how far these arms pivot. Brakes lock their position into place.

Customize a system for your application—you can create hundreds of different variations. A complete suspension arm requires at least a base, a tube, and a mount. Add components to extend your arm up to 80” from the base and expand its range of motion. Arms without a connector support up to 180 lbs. Those with a connector support up to 135 lbs., but the load it can hold decreases by 2 lbs. for every 1” over 40” from the base.

Hang your HMI in areas with frequent washdowns. Made of 304 stainless steel, these arms resist corrosion from most cleaners and detergents. They’re also gasketed at every joint to seal out moisture. Since they suspend from surfaces, they won’t take up valuable floor space. The joints pivot, so you can position your HMI right where you need it. A brake locks the position in place. Use the locking pins to set how far these arms swing to keep them out of the way. Route wire to and from your HMI through a hole that runs through the entire arm.

These arms are designed to mount to our stainless steel enclosures for positioning arms. A complete arm requires a base, tube, and mount. If you want to mount your arm to a wall or other vertical surface, you’ll need a bracket. Add an adapter if you want to tilt the enclosure. Arms that are 20" long support up to 250 lbs. For each additional inch, load capacity decreases by 2 lbs.