Find faulty seams, welding defects, and other surface-level flaws in ferrous materials. These kits come with everything you need to start inspecting parts. Apply the powder to the surface you want to inspect. Then plug in the yoke and it creates a magnetic field that draws the powder to the imperfection, making it easy to spot. Built for rugged environments, the yoke has a sealed design that stands up to chemicals and other harsh conditions. It’s also half the weight of a standard yoke and fits comfortably in your hand, so there’s less fatigue if you use it for extended periods of time.

More sensitive than natural light kits, these kits use UV light with colored dye to detect cracks, seams, and pores on machined surfaces.

Check for defects slightly beneath the surface of ferrous materials that you wouldn’t otherwise see. The yoke in these kits is powered by a battery, so it uses direct current to create a strong magnetic field that reaches just below the surface of your part. When you apply the powder, the powder will move towards any flaws, helping you identify tears, cracks, and other imperfections.

Ideal for fieldwork, these kits come with everything you need for on-the-go inspections. The yoke lasts up to eight hours on a single battery charge. Built for rugged environments, it has a sealed design that stands up to chemicals and other harsh conditions.

Test stainless steel to see if it needs to be passivated or was properly passivated. These tests detect the presence of iron from fabrication processes, which can limit stainless steel's inherent ability to resist corrosion. Often used in aerospace, pharmaceutical, and medical device industries, they meet ASTM, aerospace, and military passivation standards.

To perform a test, squeeze the dropper to apply the solution to the surface of a part. Keep the surface wet for six minutes before rinsing and drying it off. Do not scrub the solution off. If iron is detected, the surface will appear copper in color. If no copper coloring appears, the surface is clear of contaminants and is properly passivated. These bottles include enough solution to perform hundreds of spot tests.

This test is often used on all 200 and 300 series stainless steels and some 400 series stainless steel alloys. However, it’s not recommended to use this solution on 400 series stainless steel with less than 16% chromium. These stainless steel alloys will typically cause a false failure of the test.

Find welding defects and other flaws in magnetic materials. These yokes create a magnetic field that draws magnetic powder (not included) to imperfections, making them easy to spot. All operate on AC power, which creates a small magnetic field ideal for detecting flaws along the surface of materials. Powered by standard electrical outlets, these yokes have a reliable and consistent power source.

Attach an LED light to your yoke to brightly illuminate inspection areas. They’re powered by the yoke’s magnetic field, so they don’t require batteries.

Calibrate your yoke before each use with a test weight to ensure accurate test results.

With bright-colored dye and a fully equipped kit, you have everything you need to spot leaks in your HVAC system. These kits come with the correct amount of dye required for your system's size. Inject the dye into your system and scan it with the UV light—the dye is fluorescent, so it’s easy to spot most leaks right away. For small leaks, let the dye circulate for 24 hours and then inspect it again. Use the dye cleaner before you fix a leak. If the repair isn’t sufficient, you’ll be able to spot more dye.