Turn the handle of these punches while pushing down to punch holes in cork and rubber. Also known as cork borers, these tools have precision-ground edges that can be sharpened.

Softer than steel, these brass punches knock out pins and rivets without marring your work surface. If your pin or rivet is stuck or rusted, loosen it with a pin-loosening punch before removing it.

Made of materials that are Factory Mutual approved, these nonmagnetic, corrosion-resistant tools inhibit sparking. Use them to knock out pins and rivets that have already been loosened. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Nonsparking tools are not, however, classified as antistatic because they do conduct electricity.

Note: Do not use these tools in direct contact with acetylene.

These brass tools reduce marring on metal surfaces because they're softer than steel punches. Use them to align holes in sheet metal for rivets and bolts.

Made from aluminum bronze that is Factory Mutual approved, these nonmagnetic, corrosion-resistant pins inhibit sparking. They satisfy OSHA requirements for nonsparking tools for locations where flammable vapors and combustible residues are present. Nonsparking tools are not, however, classified as antistatic because they do conduct electricity. Use alignment pins to align structural components such as I-beams and angle irons for bolting, riveting, and welding.

Note: Do not use these tools in direct contact with acetylene.

Made of aluminum-bronze that is Factory Mutual approved, these nonmagnetic, corrosion-resistant tools inhibit sparking. Also known as marking punches, strike these with a hammer to mark hole centers in metal and other materials. Use before drilling to prevent your drill bit from wandering when starting a hole.

They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Nonsparking tools are not, however, classified as antistatic because they do conduct electricity.

Note: Do not use these tools in direct contact with acetylene due to the possible risk of explosion.

Protect your hands from accidental hammer strikes by gripping punches and chisels with these holders.

The included hand punch creates a clean hole and sets the snap, eliminating the need for a workbench or separate hole-punching tool. Nickel-plated brass resists corrosion, making these snaps suitable for covers and other weather-exposed fabrics.

When one end of these pins wears out, use the other one. Made from aluminum bronze that is Factory Mutual approved, these nonmagnetic, corrosion-resistant pins inhibit sparking. They satisfy OSHA requirements for nonsparking tools for locations where flammable vapors and combustible residues are present. Nonsparking tools are not, however, classified as antistatic because they do conduct electricity. Use alignment pins to align structural components such as I-beams and angle irons for bolting, riveting, and welding.

Note: Do not use these tools in direct contact with acetylene.