A built-in relay produces AC voltage output. These switches are often used with older programmable logic controllers (PLCs).

For optimal performance in tight spaces, these switches have a smaller beam and can detect smaller objects than standard photoelectric switches.

These switches have a receiver built into the housing, eliminating the need to align components and measure sensing distance during installation.

Rated IP69K, these switches can withstand high-pressure, high-temperature washdowns and temporary submersion.

Safely detect the presence or absence of an object moving at high speeds with a light beam. These switches produce a low-current, low-voltage NAMUR signal, so they won’t create sparks or ignite. ATEX and IECEx certified, they protect against explosion in environments containing flammable gases and combustible dust.

Light beams travel up to 32 ft. between the transmitter and receiver.

Easily mount these flat switches to a base or rail.

The flexible cable on these switches withstands applications that require frequent motion, such as robotics.

These intrinsically safe switches detect objects as they’re routed through the ring. They produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks. Switches are ATEX certified to protect against explosion.

Twist the sensor to detect metallic objects where explosive dust or gas may be present—the sensor rotates for front, side, top, or bottom sensing. These switches are UL and C-UL listed as well as ATEX and IECEx certified for hazardous locations.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

For use in volatile areas, these intrinsically safe switches detect objects when they pass through the slot. They use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or create sparks. ATEX and IECEx certified, they protect against explosion.

Switches accept both AC and DC input voltage.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

These switches have a longer sensing distance compared to other proximity switches with the same diameter.

Easily mount these flat switches to a base or rail.

These switches use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or produce sparks. ATEX certified, they protect against explosion in environments containing flammable gases and combustible dust. Switches sense both metallic and nonmetallic objects.

Mount proximity switches into a panel cutout or tank wall.

These switches sense when a valve is open or closed, supporting flow and temperature control within your system and offering reliable feedback.

Use high-frequency sound waves to detect chemical level.

Measure the distance to objects and the level of liquids and materials despite size, shape, or surface finish, and send that information to other parts of your system.

Clamp around sensors and switches for a secure hold.

Position proximity, photoelectric, and light beam sensors and switches.