Keep your worksite safe when working with diesel fuel, fuel oil, gasoline, and kerosene. Fire-tested to meet American Petroleum Institute (API) 607, these valves are designed to securely isolate fluid and prevent the spread of fire. They have also passed fugitive emissions testing and meet API 641 standards to reduce the risk of hazardous gas leaks.

Bolt these valves to ANSI flanges. They meet ASME standards for dimensions, material, and pressure-temperature rating. You can also attach an air-powered or electric actuator to these valves using the four actuator mounting holes. This allows you to switch them from manual to automatic operations.

These valves have a lockable handle that can be secured in place using a padlock (not included). All are full port, so they do not restrict flow.

316 stainless steel valves are more corrosion resistant than steel valves.

Flow coefficient (Cv) is the amount of water (in gallons per minute) at 60° F that will flow through a fully open valve with a difference of 1 psi between the inlet and the outlet.

A rubber-coated gate, also known as a resilient wedge, compresses against the valve seat to give these valves a tight, leakproof seal. They shut tight even when they’re installed vertically, have low back pressure, or the liquid contains solids and debris. Often called gate valves, they open and close gradually to prevent sudden starts and stops that can damage your system. Since they bolt onto flanges, they’re easier to install and remove than threaded and weld-on valves. This makes them a good choice for lines that need frequent cleaning and maintenance. You can use them in lines for water supply, reclamation, and wastewater treatment—they meet AWWA (American Water Works Association) specifications. To protect against corrosion, the body is coated with epoxy.

The stem is nonrising, so it stays in the same position whether the valve is open or closed. They’re often used in low-clearance spots. Their flanged stem housing bolts in place to make them easy to take apart for repairs. However, the flanged stem housing makes these valves heavier and larger than valves with threaded or welded stem housings.

FM-approved, these valves are often used to isolate sections of your facility’s water supply for fire suppression and protection. They bolt to flanges for easier installation and removal than threaded or weld-on valves. This makes them a great choice if you have to clean and maintain your line frequently. Also known as gate valves, they open and close gradually to prevent sudden starts and stops of flow that could damage your system. Epoxy coated, these valves resist corrosion. They’re bright red, so they’re easy to identify as fire valves.

Their rubber-coated gate, also known as a resilient wedge, compresses against the valve for a long-lasting, leakproof seal. It seals tightly even if you install these valves vertically, or if there’s low back pressure. For easy disassembly during maintenance, they have a flanged stem housing that bolts in place. However, the housing makes these valves heavier and larger than valves with a threaded or welded stem housing.

Valves with a wheel handle open and close with multiple turns for controlled, shock-resistant flow. Valves with a rising stem lift the handle as they open and lower it as they close. At a glance, you can see if flow is on or off. The stem is isolated from what’s flowing through your line, giving these valves a longer lifespan than valves with a nonrising stem. This makes them good for critical lines and lines that need to be opened and closed frequently.