A metal shell adds strength.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Reinforced with polyester fabric, these plastic bearings have load and speed capabilities comparable to metal bearings.

Permanently and securely install these self-clinching bearings into panels, with no need for precision-bored holes or machined mounts.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

Reinforced with polyester fabric, these plastic bearings have load and speed capabilities comparable to metal bearings.

Good for underwater applications, these bearings won’t swell or warp when wet.

Made of acetal with a PTFE filler, these bearings handle velocities up to twice as high as standard acetal bearings. They swivel to compensate for a small amount of shaft misalignment.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Good for underwater applications, these bearings won’t swell or warp when wet.

These bearings stand up to a wider range of chemicals than other dry-running thrust bearings.

Use these UHMW bearings in wet, corrosive environments.

Made of acetal blended with PTFE, these bearings handle speeds twice as fast as standard sleeve bearings.

Use these nylon or acetal bearings for light loads. The closed backing blocks out dust and other contaminants.

Made of FDA listed PEEK, these bearings are suitable for direct contact with food. The closed backing blocks out dust and other contaminants.

Almost nonabsorbent, these unthreaded LDPE and HDPE spacers won't swell when exposed to water.

Naturally slippery and wear resistant, acetal spacers also offer some resistance to moisture.

Use PEEK spacers as an alternative to metal spacers in high-temperature, high-stress applications. They resist chemicals, wear, and moisture.

Protect components from electrical charges.