Use the built-in connections to attach conduit without using fittings.

Close off unused outlets.

These boxes have an open back to accommodate extra-deep low-voltage devices.

Internal mounting bosses enable you to attach panels or DIN rail inside the enclosures using self-tapping screws. Made of polycarbonate, these nonconductive enclosures resist denting, chipping, and cracking.

PVC enclosures are nonconductive and chemical resistant, withstanding solvents, alkalies, and acids.

Internal mounting bosses or mounting brackets enable you to use panels or DIN rail to mount components. These enclosures have a clear cover, so you can inspect components without opening the enclosure.

Fiberglass enclosures are stronger than polycarbonate enclosures and nonconductive.

View all sides of your installed components.

Made of polycarbonate, these enclosures resist denting, chipping, and cracking better than stainless steel enclosures.

Small and lightweight, these enclosures are used with sensors, switches, and testing devices.

These enclosures allow you to inspect your electronics without opening the cover.

Made of nonconductive polycarbonate, these enclosures withstand prolonged submersion in water while protecting electronics from dents, chips, and cracks.

Able to withstand periodic submersion in water, these enclosures offer our highest level of protection from liquids. They’re made of fiberglass to resist impact and corrosion from solvents, alkalis, and mild acids.

Install these enclosures on control panels and walls and inspect what’s inside without exposing their contents in wet and outdoor locations.

Made of nonconductive polycarbonate, these enclosures withstand prolonged submersion in water while protecting electronics from dents, chips, and cracks. A clear cover lets you monitor the inside without opening them.

Mount these enclosures directly to machine control panels in wet environments and view the contents without opening them.

The unique shape of these enclosures provides a handle to hold scanners, detectors, and remote switches.

Protect tablet computers, touch displays, and readouts in these specially sized enclosures. They are rated IP65 for protection from spraying water.

Use these open boxes with adhesive for electronics (also known as potting compound) to encase electronic assemblies and protect them from vibration, tampering, moisture, and corrosives.

Give switches and outlets a finished look.

Pair wall plates and adapters to create a custom cover for existing receptacles and switches to give them a rejuvenated look, no rewiring required.

A large angled opening provides an exit point for cords that run behind walls.

Save time when wiring connections in a junction box; these blocks come already installed in an enclosure.

Keep personnel safe from electric shock with ground fault protection.

Save energy by automatically turning off unused outlets. The master outlet controls five outlets and shuts off power to the other outlets when a device plugged into the master is turned off.

These curved outlet strips clamp onto a pole or table leg.

Connect multiple devices from a single outlet.