Use where high loads and speeds are not required.

Made of FDA-listed materials or FDA compliant, these bearings are for use in food applications. They also withstand caustic and washdown environments.

Reinforced with polyester fabric, these plastic bearings have load and speed capabilities comparable to metal bearings.

Permanently and securely install these self-clinching bearings into panels, with no need for precision-bored holes or machined mounts.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

Reinforced with polyester fabric, these plastic bearings have load and speed capabilities comparable to metal bearings.

Good for underwater applications, these bearings won’t swell or warp when wet.

Made of acetal with a PTFE filler, these bearings handle velocities up to twice as high as standard acetal bearings. They swivel to compensate for a small amount of shaft misalignment.

A metal backing adds strength.

Good for underwater applications, these bearings won’t swell or warp when wet.

These bearings stand up to a wider range of chemicals than other dry-running thrust bearings.

Use these UHMW bearings in wet, corrosive environments.

These nylon bearings swivel inside their housing to compensate for over 20° of shaft misalignment.

Use these nylon or acetal bearings for light loads. The closed backing blocks out dust and other contaminants.

Handling speeds twice as fast as standard mounted sleeve bearings while limiting wear on your system, these bearings are made of PTFE-filled acetal.

Made of high-performance plastic, these insert bearings last longer than metal insert bearings. They also don’t require lubrication.

These fiberglass bearings are lightweight, nonmagnetic, and won’t conduct electricity.

Replace worn and damaged bearings or press-fit bearings into tubing or pipe to create a roller.

Multiple thread channels (also known as thread starts) create faster linear travel than lead screws with a single thread start.

Multiple thread channels (also known as thread starts) create faster linear travel than lead screws with a single thread start.

Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.