Protect components from electrical charges.

Almost nonabsorbent, these unthreaded LDPE and HDPE spacers won't swell when exposed to water.

Use PEEK spacers as an alternative to metal spacers in high-temperature, high-stress applications. They resist chemicals, wear, and moisture.

PTFE spacers have a slippery surface and surpass most plastic spacers when it comes to chemical resistance and performance in extreme temperatures.

Protect components from electrical charges.

Also known as saddle washers, the curved end fits against round objects such as tube and pipe.

Stick these supports to surfaces where you don't want to drill a hole. The snap-in end can be released for repairs and upgrades.

Wings add tension to strengthen the hold in a hole. The other end is releasable for repairs and upgrades.

Thread the male connection into a tapped hole and snap the other end into a panel for a secure hold that can be released for repairs and upgrades.

In enclosures and other places where you don’t want to drill a hole, mount circuit boards and other thin panels with these supports.

As you tighten your screw, the rolled collar compresses under the head to create an insulating barrier between a screw shank and a mating surface.

A slit running along the length of these bearings allows you to quickly slip them into a housing—no tools required.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Good for underwater applications, these bearings won’t swell or warp when wet.

Made of acetal with a PTFE filler, these bearings handle velocities up to twice as high as standard acetal bearings. They swivel to compensate for a small amount of shaft misalignment.

Compensating for minor shaft misalignment and not requiring lubrication, these sleeve bearings swivel to self-align and are dry running. They don’t need a housing and you can install and replace them without any tools because they’re slip fit.

Permanently and securely install these self-clinching bearings into panels, with no need for precision-bored holes or machined mounts.

A metal shell adds strength.

These bearings stand up to a wider range of chemicals than other dry-running sleeve bearings.

Good for underwater applications, these bearings won’t swell or warp when wet.

Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

A metal backing adds strength.

Good for underwater applications, these bearings won’t swell or warp when wet.

Use these UHMW bearings in wet, corrosive environments.

Made of acetal blended with PTFE, these bearings handle speeds twice as fast as standard sleeve bearings.

Use these nylon or acetal bearings for light loads. The closed backing blocks out dust and other contaminants.

Embedded lubricant particles increase the load capacity of these bearings while also making them slippery.

Easier to install than grommets, push these bushings through your mounting hole to dampen vibration. Use them with a vibration-damping washer to isolate vibration.

In addition to having a wider temperature range than our other ribbed vibration-damping bushings, these have excellent weather resistance.

In addition to having a wider temperature range than our other vibration-damping washers, these have excellent weather resistance.

Protect development boards from dust, water, and debris by mounting them to DIN rails inside control cabinets.

Ridges on the inside of these bearings wipe away dust and debris as the bearing travels on a shaft.