These pumps can be submerged or connected remotely to a pipe in your line. Use them to circulate water in small tanks, cooling baths, fountains, and other low-flow applications. Plug in to activate. Do not run dry. Not for use with salt water or flammable liquids.

Magnets turn the impeller so there's no shaft seal to wear out. Submerge these pumps to circulate water in small tanks, cooling baths, fountains, and other low-flow applications. Plug in to activate. Do not run dry.

Clean up water in flooded areas without a sump pit. Install these pumps in debris-free water that’s at least 2" deep. They activate when plugged in. You can add a plug-in switch to control when the pump activates. Submerge while in use.

Note: Pumps must be filled with liquid before use. They need a constant flow of liquid and cannot run dry.

Place your pump inside this basin for ground-level applications and below-ground use without a sump pit. Basin has a vent on top.

Convenient for applications where a sump pit is impractical, these pumps include a basin with a vent on top. They handle raw sewage water with solids up to 2" in diameter. The float switch has a separate cord that can unplug, so you can replace the switch without replacing the whole pump.

If the primary float fails, the backup float kicks in and an alarm sounds to indicate float malfunction. The floats are enclosed in a mounting cage to minimize false switch activation. Use these switches to replace an existing switch, or pair them with a plug-in activated pump that operates on 15 amps or less to control when the pump activates.

An alarm and a red light alert you when water levels rise too high. A float detects water level and activates the alarm. Alarm has a plastic housing that meets NEMA 3R for protection from dirt, falling liquids, and light splashing.

Convenient for applications where a sump pit is impractical, these pumps include a basin with a vent on top. Pumps have a switch that activates on increasing pressure caused by rising water levels. Use with debris-free water.

Don’t let a power outage cause flooding. Powered by water flow in your supply line, this pump works as a backup to your primary sump pump. Use with debris-free water. Intake has a foot valve to prevent debris from entering your line. The water inlet has _3/4 NPT female threads and comes with a push-to-connect fitting for _3/4" ID tubing, so you can make either connection. The float switch is wired to the pump.

Activate your pump in dirty water that contains sludge and sewage.

Convenient for applications where a sump pit is impractical, this pump includes a basin with a vent on top. It has a float switch with a separate cord that can unplug, so you can replace the switch without replacing the whole pump. Also known as an effluent pump, it accommodates solids up to _3/4" in diameter. It is often used with liquid waste that has passed through a septic tank, so most solids are removed.

Hang these switches in a sump pit to detect rising water levels. Use them to replace an existing switch, or pair them with a plug-in activated pump to control when the pump activates.

Since these switches activate on increasing pressure caused by rising water levels, they have no floats to catch on sump pit walls. Use them to replace an existing switch, or pair them with a plug-in activated pump to control when the pump activates.