We will reply to your message within an hour.
Retract the nose by pulling the knob.
Lock the nose into the retracted position by pulling the knob and rotating it 90°.
The ring allows you to attach these spring plungers to a lanyard.
Lock the nose into the retracted position by pulling the ring and rotating it 90°.
Use the lanyard as a tether to secure the spring plunger to machinery and prevent accidental drops.
Lock the nose into the retracted position by pulling the handle and rotating it 90°.
Thread onto machinery or attach a knob or handle to the threaded spindle.
Install by hand or with a hex key in low-clearance applications.
Install these spring plungers with a screwdriver—they're slotted on one or both ends.
Install with a hex key for more torque than slotted ball-nose spring plungers.
Install with a driver.
Install with a hex key for more torque than slotted long-nose spring plungers.
Slotted on both ends for installation with a screwdriver.
Fasten from the nose end with a wrench for more torque than slotted long-nose spring plungers.
Install spring plungers from the nose end without depressing the nose.
Mount ball-nose and long-nose spring plungers to fixture surfaces.
Add a knob or handle to the threaded shank. A spring-loaded, nonlocking retaining ball pops out when the pin is pushed through a hole, and retracts when the pin is pulled out.
Use a screwdriver to install these receptacles in a threaded hole.