The wheel flares out as it spins for use on depressions and curved surfaces.

Remove buildup and fluff packed-down bonnets to extend their life.

A special fastener on the back of these flexible discs allows you to easily swap one disc for another. Use with a backup pad on grinders for bits and burs.

The edge of the wheel is tapered for polishing joints, grooves, and crevices.

Layers of cloth are sewn together, making these wheels more rigid than those for curved surfaces.

Long, soft cotton strings conform to irregular surfaces and hold on to burring compounds longer than other wheels.

Holes in the hub allow air to flow through so the wheel stays cool and compound lasts longer. Also known as airway buffs.

Softer than flat-surface wheels, these conform to curves and contours.

Made from alternating strips of cotton and sisal, these wheels remove less material, leave fewer scratches, and conform better to curves and contours than flat-surface wheels. Also known as finger-style buffs.

Loose layers of cloth conform to curves and contours. Also known as jewelers’ buffs.

Shaped for use on inside cylinders or on irregular surfaces.

Remove scratches from your workpiece with these hard bobs.

Each of these sets comes with four differently shaped stones.

Also known as Crystolon stones, these abrade quickly to create a smooth or extra-smooth finish.

The abrasive is specially treated for use on aluminum, brass, bronze, and other soft metal molds and dies.

Sized for tight spaces, these small pads sand flat and curved surfaces. They have a flexible foam layer that gives you more control over sanding pressure, creating finer and more consistent finishes.

The soft abrasive is good for fine hand-polishing of metal surfaces that require the smoothest finish possible after an abrasive sequence. Also known as crocus cloth.

Keep an assortment of sheets that prevent dust and debris from building up on the abrasive surface close at hand.

These sheets resist deterioriation when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

A layer of mesh lets sanding dust and debris escape during use, preventing material buildup on the abrasive surface. These sheets resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

These sheets have a long-lasting diamond abrasive.

Peel and stick to your sanding tool. When it’s time to change the sheet, peel it off.

Peel and stick to your file handle. When it’s time to change the sheet, peel it off.

These sheets have a long-lasting diamond abrasive.

Quickly attach, remove, and reuse these hook-and-loop sheets with triangular detail sanders.

Quickly attach, remove, and reuse these hook-and-loop sheets with pole sanders.

This film abrades quickly and prevents material buildup.

Diamond cuts more quickly, lasts longer, and leaves a finer finish than other lapping grains.

Also called pad drivers, these are required to hold pads in place.

Super soft suede-like cloth polishes surfaces without scratching and removes fine dirt.