Plastic pins are a nonconductive and nonmagnetic alternative to metal dowel pins. Use them as pivots, hinges, shafts, jigs, and fixtures to locate or hold parts.

Oversized to fit worn and enlarged holes, these pins work well as repair and replacement parts.

Grooves hold these pins in place, and a round head gives them a finished appearance.

Center-groove pins are often used in place of clevis pins or to create T-handles. The grooved center locks pins in position, while the smooth ends act as a pivot. Also known as type E pins.

Grooves run the full length of these pins for a firm hold that won't spin. Use them in place of standard dowel, spring, and taper pins to fasten parts. Also known as type A pins.

Barbs bite into plastics and soft metals such as aluminum for a strong hold, and a round head gives a finished appearance.

Use these as pivot or hinge pins. The knurled half locks pins in position, while the smooth half acts as a pivot.

The full length of these pins is knurled for a tight grip that won't spin.

Join two pieces of wood with these dowel pins. When glued, they expand for a tight fit.

The flat side of these pins relieves trapped air, making them easier to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

Pass wires and other components through these hollow pins.

A 60° beveled head fits into a countersunk hole.

A thick shoulder makes these pins more rigid than standard ejector pins.

The grooves in these pins grip plastics and other soft materials. Press them in to hold panels together. Also known as PEM® TKA and TK4 TackSert pins.

Interlocking teeth help these pins resist sliding when exposed to vibration. They have a slot that presses closed when the pins are inserted so they don't flex after installation.

For tough jobs, these spiral pins are 30% stronger than our standard coiled spring pins. They remain flexible after installation to absorb shock and vibration, and work well in holes that are out of round.

Lock the nose in the retracted position by pulling the knob and rotating it 90°.

Designed with a flange to keep the plunger from being pushed through a hole when the ball is depressed.

Noses are up to four times longer than standard long-nose press-fit spring plungers.

Coiled spring pins are flexible after installation, so they absorb shock and vibration better than slotted spring pins. They also have higher dynamic load capacities and accommodate wider hole tolerances.