Press Screws | McMaster-Carr

	REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)

REACH Compliant

	For Hole Diameter For Hole Diameter

0.085"

	For Minimum Material Thickness For Minimum Material Thickness

	Base Diameter Base Diameter

	Number of Mounting Holes Number of Mounting Holes

	Thread Spacing Thread Spacing

Coarse

Fine

	Drill Bit Size Drill Bit Size

	Tensile Strength Tensile Strength

	For Minimum Length Between Hole Center and Sheet Edge For Minimum Length Between Hole Center and Sheet Edge

291 Products

About Threaded Studs and Rods

Hole-Mount Screw Clamps

Also known as press screws, mount these clamps through a drilled hole and turn the crank to move the jaw end of the screw in and out.

Screw Clamps

The spring-loaded tips on these clamps swivel in all directions to make maximum contact with angled and uneven workpieces.

Revolving Screw Clamps

When loosened, you can spin the body of this clamp around its mounting point for better access to the workpiece.

Quick-Clamping Coil-Threaded Rods, Screws, and Nuts

Combine fast-threading components to build a clamping assembly.

Fasteners

Steel Press-Fit Studs

These steel studs are zinc plated to resist corrosion in wet environments.

Stainless Steel Press-Fit Studs

18-8 stainless steel studs have good chemical resistance.

Press-Fit Captive Panel Screws

Install in soft material such as aluminum and low-carbon steel at least 0.036" thick with an arbor press or similar pressure tool.