Use these bearings in applications with frequent starts and stops because they operate with very little friction.

These bearings stand up to a wider range of chemicals than other dry-running sleeve bearings.

Good for underwater applications, these bearings won’t swell or warp when wet.

Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

An aluminum shell adds strength.

Handle heavy loads that frequently start and stop along shafts—these bearings contain extra iron and slippery PTFE lubricant. They’re thrust bearings, which means they support loads parallel to the shaft.

Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

A metal backing adds strength.

Made of acetal blended with PTFE, these bearings handle speeds twice as fast as standard sleeve bearings.

Ridges on the inside of these bearings wipe away dust and debris as the bearing travels on a shaft.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance.

Sleeve bearings outperform ball bearings in dirty environments. Use them for low speed applications.

The Frelon liner on these bearings allows them to stand up to a wider range of chemicals than other flange-mounted linear sleeve bearings.

With two bearings mounted in one housing, these sleeve bearings can handle heavier loads than standard mounted linear sleeve bearings.

With two bearings mounted in one housing, these sleeve bearings withstand heavy loads. Use them on round support rail shafts for applications that require maximum rigidity.

A carbon fiber-reinforced insert or PTFE liner reduces wear, handles shock loads, and eliminates the need for lubrication.

With at least 55° of ball swivel, these rod ends accommodate greater misalignment than any other internally threaded rod end we offer.

Made of cadmium-plated steel, these internally threaded rod ends generally handle higher loads than stainless steel, aluminum, and nylon rod ends.

Made of stainless steel, these internally threaded rod ends provide excellent corrosion resistance.

These anodized aluminum rod ends are lighter than stainless steel rod ends and have good corrosion resistance. Internal threads mate with rod end bolts, threaded rods, and other components with male threads.

These internally threaded steel rod ends handle loads that are at least 25% higher than other comparably sized rod ends.

A slippery PTFE liner reduces wear and eliminates the need for lubrication.

A slippery PTFE liner reduces wear and eliminates the need for lubrication.

A handle on the side of the carriage locks the carriage in place.

With a wide base, these sleeve bearing carriages stabilize moment (twisting) and off-center loads better than standard carriages. Use in areas where multiple carriages or rails won't fit.

For applications with low clearance, these carriages protrude less than 5 mm above their rails.

Build loops, circuits, and curved paths in assembly stations and other repetitive processes.

Made with Frelon bearings, these slides have over four times the load capacity of standard positioning slides.

A layer of tin-plated steel adds structural support and makes this PTFE easy to form.