No need for clamps or connectors—duct and fittings have a male end that is slightly smaller than its female end for simple assembly.

Fittings have gaskets which create a tight seal—you don't need to seal joints with coating or tape.

Bolt flanges to equipment to start a run of duct.

Built to withstand temperatures up to 1000° F, these vent pipes and fittings are for use with boilers, furnaces, stoves, and other equipment that is fired by coal, gas, oil, propane, or wood.

Hose has a single thin layer of PVC-coated fiberglass for venting smoke, water-based paint fumes, and welding fumes.

Unlike other duct hose that has a metal spiral, this hose has a plastic spiral that will not rust.

Increase or decrease the hose diameter by up to 25% with a two-handed twist.

This general purpose hose for blowing and vacuum applications has a thick PVC wear strip that protects against damage caused by dragging.

A polyurethane liner gives this hose extra strength to handle high pressure and vacuum applications.

A smooth interior allows for unrestricted flow and makes this hose easy to clean.

Attach conduit to a knockout in an outlet box or enclosure.

Also known as conduit bodies, these ports provide access to wire and cable inside PVC conduit for pulling, splicing, and maintenance. They are also used to change the direction of a run.

Also known as conduit bodies, these ports provide access to wire and cable inside thick-wall (rigid) metal conduit for pulling, splicing, and maintenance. They are also used to change the direction of a run.

Connect different sizes of conduit.

Visually identify different runs of wire and cable in machine and equipment wiring.

Join pieces of conduit.

Also known as Type B, this conduit is more crush and abrasion resistant than liquid-tight flexible plastic conduit.

Also known as Type A, this conduit meets the demands of continuous motion while sealing out liquid when used with liquid-tight fittings.

In areas exposed to washdowns, chemicals, and corrosion, install this stainless steel raceway system that has gaskets at the connection points.

With more than one channel, this raceway allows you to separate power and data wiring to prevent signal interference.

Surface mount with the adhesive back to route low-voltage data and control cable where you can't get inside walls.

Faster to install than standard slotted wire duct, attach this to flat, clean surfaces.

This wire duct completely encloses wire and cable.

Protect cable from carts, pedestrians, and other light indoor traffic.

Often used to protect wire, cable, and hose in robotics and other automated applications, this highly flexible sleeving withstands continuous motion without tearing or fraying.