Also known as firefighters' boots, these meet the NFPA 1971 standard for structural firefighting. They have a Kevlar lining throughout and a foam insole to withstand ambient heat up to 500° F. These boots are knee high and made of water-resistant blended rubber. They have a safety toe that meets ASTM F2413 standards for protection against impact and compression. A shank provides arch support by distributing weight during strenuous work, such as climbing ladders.

These boots contain perfluoroalkyl and polyfluoroalkyl substances (PFAS) as part of their moisture barrier. PFAS are a class of fluorinated organic chemicals containing at least one fully fluorinated carbon.

Use these waders to stay dry when you’re in deep water, mud, and sludge. Straps are adjustable to modify the fit; loop through your belt and secure with a snap. All waders fit over socks.

Inner and outer seam lengths are approximate and measured from the bottom of the heel to the top of the wader.

Hang wet boots to dry them out. These racks mount to the wall and fit a maximum of four pairs of boots.

No need to change into high-visibility pants—just slip these gaiters on to stay visible. Their fluorescent yellow color and reflective stripes make you easy to spot when visibility is low. They meet Class E ANSI/ISEA 107, so you’ll be seen from across shop floors or around moving vehicles. If you need to meet Class 3 visibility requirements, pair them with a Class 2 or Class 3 vest, shirt, or jacket—this combination keeps you seen from _1/4 mile away. Made of polyurethane-coated polyester, they'll keep your shins dry and protected. They’ll fit over your bulky work boots and pants.

These waders go up to your chest to keep you dry in deep water, mud, and sludge. They are PVC, so they resist oil. These waders have adjustable suspenders to modify the fit. All waders fit over socks. They have a safety toe and meet ASTM F2413 standards for protection against impact and compression.

Inner and outer seam lengths are approximate. The outer seam length is measured from the bottom of the heel to the top of the wader.

Protect your feet from electrical hazards without switching footwear—these dielectric covers slip over your boots. They’re rated to ASTM F2413 and insulate against electrical hazards up to 20,000 volts AC. A deep-cut heel grips ladder rungs and stair edges to keep your footing secure when climbing.

Order your normal boot size. For large work boots, order one size up.

Repair rips, split seams, and detached soles to stop leaks in shoes, boots, and waders. These epoxy adhesives create a strong, flexible seal that keeps water out, so they’re also used to coat seams. Use on leather, plastic, and rubber. They fully harden in 10 hours and dry clear.