These steel rod ends handle loads that are at least 25% higher than other comparably sized rod ends. PTFE allows smooth rotation and eliminates the need for lubrication.

These clevis rod ends offer more corrosion resistance than standard steel clevis rod ends. Also called yoke-end linkages, they support pivoting movement along one axis when threaded onto shafts, rods, valve pistons, and other assemblies.

Make quick adjustments to these rod ends by inserting and releasing the clevis pins without the need to bend them into place. Also called yoke-end linkages, they support pivoting movement along one axis when threaded onto shafts, rods, valve pistons, and other assemblies. All are zinc-plated steel for moderate corrosion resistance.

These rod end bolts are good for wet and corrosive environments—for maximum mounting flexibility, cut the fully threaded shaft to whatever length you need. Also known as swing bolts and eyebolts, rod end bolts have no moving parts. They're designed to make pivoting or hinge movements in applications that don't need to compensate for misalignment.

Seals keep out dirt and an oil-embedded polyester foam insert slowly releases lubricant for a long life. You can remove the insert to add more oil if it starts to run dry. These rod ends have an eyelet and a ball that swivels to support angular misalignment. Made of zinc-plated steel, they have moderate corrosion resistance.

In addition to offering superior chemical resistance, these lightweight, fiber-reinforced nylon rod ends also reduce noise and vibration. Also called yoke-end linkages, they support pivoting movement along one axis when threaded onto shafts, rods, valve pistons, and other assemblies.

A double row of precision ball bearings allows high speeds and smooth operation. Seals keep lubricant in and dirt out.

Create pivoting connections in applications that require high shear strength—the partially threaded shank of these rod end bolts withstands more side force than a fully threaded shank. Also known as swing bolts and eyebolts, they are used to create hinges, turnbuckles, and tie downs. Unlike ball joint rod ends, these rod end bolts are made from a single piece of metal, so they wear down more slowly and have a more controlled swing. However, because they do not have a moving ball joint, they do not compensate for angular misalignment. Made from steel, they are stronger and more wear resistant than stainless steel rod end bolts, but they are not as corrosion resistant.

Pivot and hinge components in wet and corrosive environments with these stainless steel or brass rod end bolts. They're commonly known as swing bolts and eyebolts. With no moving parts, they're less likely to wear out than ball joint rod ends, although they don't compensate for misalignment as effectively. Use them to guide and connect components, such as tubing, or as a turnbuckle to tension wire and cable. They can also be used as tie downs and hinges.

With external threads, these bolts hold fast to female threaded components in applications where high shear strength is required, such as water pumps, alternators, and motor mounts. Because the shank is only partially threaded, they handle a greater amount of force from the side than bolts with a fully threaded shank.

These alloy steel rod end bolts have the highest tensile strength of any steel fully threaded rod end bolt we offer. For maximum mounting flexibility, cut the fully threaded shaft to whatever length you need. Also known as swing bolts and eyebolts, rod end bolts have no moving parts. They're designed to make pivoting or hinge movements in applications that don't need to compensate for misalignment.