Made of yellow zinc-plated steel, these metric leveling mounts are more corrosion resistant than nickel-plated steel leveling mounts.

Made entirely of 316 stainless steel, these metric mounts have superior corrosion resistance.

Well-suited to damp environments, these metric mounts have a stainless steel stud and nut for corrosion resistance.

Made of 303 stainless steel, these metric mounts resist corrosion from water and most chemicals.

Made of 303 stainless steel, these metric mounts resist corrosion from water and most chemicals.

Install these mounts on machines without feet.

Adjust the swivels on these mounts to level equipment on uneven surfaces for protection during earthquakes.

Thread these mounts into machinery to level them on uneven floors in sanitary environments such as food-processing areas.

Higher deflection ratings translate to greater vibration and shock isolation.

An interlocking steel frame in these mounts prevents collapse, even if the rubber fails.

Select these bumpers for applications that require specific load capacities. All are reinforced with a base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Twist these bumpers into a threaded hole.

These bumpers withstand temperatures up to 300° F, which is twice as high as our other load rated bumpers. Use them in applications that require specific load capacities. All are reinforced with a base plate for strength. Often used as feet, spacers, and vibration dampers, these bumpers absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Twist them into a threaded hole.

Select these bumpers for applications that require specific load capacities. All are reinforced with a base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Mount these bumpers on a threaded stud.

Use these buttons to support and position workpieces and fixtures from the bottom or side. Their hex shape lets you screw them into a threaded hole with a wrench or socket.

Support rounded or irregularly shaped workpieces from the bottom or side with minimal contact.

Maintain consistent alignment in mating parts by installing a pin in one part and a liner in the other.

Sealed at the top to prevent debris from getting inside and making them seize up, these guide pins are a good choice for machining fixtures.

Threading makes these guide pins easier to remove and replace than press fit, so they're useful for high-wear applications.

Install these keys in a drilled and reamed hole to locate fixtures and vises on your machine table. Also known as sine keys.

These clamps wedge against the workpiece ID to grip cast, unfinished, or uneven parts, leaving the outside clear for machining.

Set one of these clamps between two workpieces in a fixture and tighten the screw to push the clamp's sides out for a secure hold.

Build these components into fixture plates, machine subplates, and tombstones for quick changes. The system clamps and locates at the same time for accurate positioning with repeatability of ±0.0005".

Even under extreme drilling pressure, these metric bushings won't press through your jig plate. A flanged head on the top of the bushing acts as a stop, preventing it from moving as you push down your drill bit, reamer, or other cutting bit.