These lights are UL listed for environments where fuels, solvents, acetylene, and other hazardous substances may be present.

Direct your signal with these lights; they flash in one direction.

Place these lights in full sun and their batteries charge during daylight hours. Lights automatically switch on at dusk and off at dawn.

These lights can switch between continuous, flashing, or revolving.

Mount these lights to the top of towers to warn low-flying aircraft.

Small as hockey pucks, these lightweight strobe lights mount to surfaces and are unobtrusive when they’re turned off.

Easier to spot than other strobe lights, these lights emit bursts of multiple flashes.

These strobe lights flash multiple times per cycle, making them easier to spot than standard strobe lights.

Easier to spot than other strobe lights, these lights emit bursts of five flashes per cycle.

Mounted on a tripod, these lights stand higher for greater visibility than other strobe lights.

Screw into a standard medium-base light socket.

Lights have a watertight O-ring seal.

Make a custom panel light with your choice of light and lens cap color.

Lights combine high-visibility strobes with a buzzer that warns workers of hazards even when they’re outside a direct line of sight.

The revolving motion of the light makes these more visible than flashing lights.

These lights have lenses that snap in and out, so you can easily swap colors or change their position in the stack.

Design a stack light with your choice of light pattern and color. Start with a base, then add up to five modules total—twist and lock them together.

Use these lights in tight spaces in place of a tower. They emit three colors from a single lens.

These lights emit three colors from a single lens and can be mounted in tight spaces where a tower will not fit.

Get notified about equipment issues even when you aren't around your machines. These lights connect to your computer via Ethernet, allowing you to set up email alerts when there is a problem with a machine, server, or conveyor.

Good for tight spaces where a tower of lights won't fit, these emit three colors from a single lens.

Direct traffic with these colored lights.

Rated for use in damp locations, these lights withstand humidity and moisture.

Mount add-on heads in remote areas to extend emergency lighting.

Connect the battery pack to your existing fluorescent light to convert it into an emergency backup light.

These lights produce a wide beam of uniform light to fill large, open areas with ceilings up to 18-ft. high.

Mount lights in recessed spaces so the lens is flush with the wall.

Rated IP65, these lights are sealed to protect against light washdowns from a garden hose. They have a height-adjustable stand and light heads that pivot up and down to direct light where it's needed.

The handle on this floodlight also acts as a stand—pivot it 360° to aim light where it's needed. This floodlight is small and easy to carry to job sites that don't have electrical power.

A flexible design allows these lights to be suspended above, wrapped around, or routed through areas on the job site.

Bring light to areas that don't have electrical power service.

A movable head lets you aim light where it’s needed most in areas that don't have electrical power service.

Because these lights are compatible with DeWalt rechargeable batteries, you can keep one type of cordless tool battery on hand. Their heads pivot to aim light where it's needed in areas that don't have electrical power service.

With a NEMA 4X rating, these lights resist degradation when exposed to corrosive liquids, withstand liquids sprayed during washdowns, and are dust tight.

Small enough to keep in your shirt pocket, these penlights are rated for use in environments where hazardous material is present.

Rated for use in environments where hazardous material is present.

Rated IP07, these headlamps withstand temporary submersion in a maximum of one meter of water for up to 30 minutes.

Gently bend these single-use lightsticks to activate.

Mount these lights near entry doors, loading areas, and driveways to cast an even glow of light.

Mount this light on a pole to illuminate pedestrian areas such as streets and walkways.

These lights automatically turn on when movement is detected and off when an area is unoccupied.

These lights are UL listed for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.

Powered by the sun, these security lights function in areas that don’t have access to electricity. They’re often used to shine light on parking lots, landscaping, signs, entryways, and other outdoor spaces.

Add these lights to a forklift to improve safety. They contain a turn light, brake light, and backup light.

This light rotates 360° horizontally and 180° vertically to illuminate any spot around a vehicle.

Use the included bracket to mount these signs perpendicular to a wall or ceiling. They meet UL 924 regulations for visibility.

No electricity or batteries needed—expose these signs to ambient light and they stay visible in the dark.