Aluminum is a good choice for damp areas and outdoor use. Hooks with a 2" opening at each end secure planks to end frames. Rungs on the underside are for use as hand grips. Planks have a perforated surface for slip resistance and to reduce debris buildup. End hooks are offset to allow for continuous planking of large scaffolds.

Note: Length is measured from center-to-center of end hooks.

Note: Planks meet OSHA and Cal/OSHA dimensional and construction standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe set-up and operating practices.

Adjust the length of these planks to create a work platform on ladder jacks, trestle ladders, and other supports. The surface is ribbed to prevent slipping.

Note: Planks that have OSHA or Cal/OSHA specifications listed meet dimensional and construction standards. Check local, state, and federal codes, including OSHA, for safe setup and operating practices.

The most commonly used and cost-effective planking for scaffolding walkways. Install three of these planks side-by-side to create a full platform atop standard 5 ft. wide scaffold frames. Hooks with a 2" opening at each end secure these planks to end frames. Their plywood walking surface can be replaced with standard _5/8" thick plywood when worn.

Note: Length is measured from center-to-center of end hooks.

Note: Planks meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices.

Also known as ladder jacks, these supports hold a plank between two straight or extension ladders to create a scaffold. Supports fit round or D-rungs, attaching to three rungs on each ladder. Use the adjustment notches to set the angle of the plank. Capacity is 500 lbs. per pair.

Note: Ladders and planks must have a minimum 250-lb. capacity.

Safely climb inside your scaffold when surrounding space is tight. These planks have an access door that swings open to reach your work platform. They’re made of plywood—the most commonly used and cost-effective planking material for scaffolds. Hooks at each end secure these planks to end frames. Length is measured from center-to-center of the end hooks.

Note: Planks meet OSHA and Cal/OSHA dimensional and construction standards. Check local, state, and federal codes, including OSHA, for safe set up and operating practices.

Use an additional plank (sold separately) to create a platform that spans a standard 5 ft. wide scaffold. They do not include an access door.

With a tripod base and adjustable legs, these stands help you create a stable, level work platform on stairs, slopes, and uneven ground. Pair with scaffold planks or stages. A pair holds up to 600 lbs. The legs adjust in 1 _1/2" increments, so you can set each one to the exact height you need. Rubber feet keep them from slipping on smooth surfaces. Made of aluminum, these stands are lightweight and corrosion resistant. When your work is done, fold them flat and store them, or use the handle to carry them to another job.

Note: Work platforms that have OSHA specifications listed meet dimensional and construction standards. Check local, state, and federal codes, including OSHA, for safe set up and operating practices.