The rubber grip provides protection up to 1,000 volts AC.

The small size and spring-loaded jaw lets you make quick cuts with one hand.

With a short-nosed jaw, these cutters force the material being cut deeper into the jaw for maximum leverage. The short jaw also allows you to cut one side of a chain link or padlock hasp without hitting the other side.

Insulated handles protect against shock from accidental contact with live electrical circuits. These cutters are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Slice through bolts and chain with low effort.

Cut rods and bolts while leaving their threads intact.

Make clean cuts on threaded rod with the pull of a trigger.

Cut left-hand external threads on bolts, studs, and rods.

Use these dies with Ridgid pipe and conduit threader die heads on Ridgid pipe and conduit threaders.

Use these dies with Ridgid pipe and conduit threader die heads on Ridgid pipe and conduit threaders.

Add or replace parts such as drive adapters, die sets, and drive bars for the Ridgid Large Size Pipe and Conduit Threader Adapter.

Clamp these dies around your workpiece, so you can start thread repair anywhere along the length of a bolt, stud, or rod. They're hex shaped for use with conventional wrenches.

Repair rusted and damaged left-hand screw threads. These dies are hex shaped for use with conventional wrenches.

Renew rusted and damaged pipe and conduit threads.

Repair the broad, square threads on Acme threaded studs and rods. These dies are for general purpose Acme threads with a Class 2G thread fit.

Use a single set for many sizes of internal and external threads. All sets include tap and die wrenches.

Renew external threads in a wide range of sizes. The dies in these sets have a narrower width than standard dies, making them a good choice for thread repair in tight spots.

Clamp these dies around your workpiece, so you can start thread repair anywhere along the length of a bolt, stud, or rod.

Secure carbide inserts inside these holders for stable turning.

Fit these holders directly into a lathe tool post or appropriately sized holder without the need for a tool block.

Deliver coolant through the holder to keep workpieces cool while boring tough materials, such as steel, stainless steel, and nickel-based alloys.

Pair these holders with a tool block for right- and left-hand mounting in a lathe.

Install these inserts into a compatible holder to cut external or internal threads on a workpiece.

Pair these holders with a threading insert or a grooving insert to make cuts on the outside of a workpiece.