PTFE provides a slippery surface that keeps threads from binding. These sealants are anaerobic, so they don’t begin to harden until coated surfaces are threaded together, blocking exposure to air.

Sealants with low locking strength prevent threads from loosening due to vibration and can be adjusted without tools.

PTFE provides a slippery surface that keeps threads from binding. These sealants never fully harden, remaining pliable enough to self-heal and stop leaks before they start, so they’re often used in high-vibration applications that could cause standard thread sealants to fail. Since they have low locking strength, these sealants can be adjusted without tools.

Gasoila sealants are designed specifically to resist gasoline and fuel oils, making them best for motors, nozzles, pump assemblies, and fuel lines.

VOC regulations restrict sales of sealants that cannot be sold to the listed jurisdictions/areas.

Much thicker than sealants for fine threads, these sealants bridge the gaps between coarse threads. Threads coated with these sealants can be installed multiple times without recoating. They have low locking strength, so they prevent threads from loosening due to vibration and can be adjusted without tools. They meet NSF/ANSI 61 for use with drinking water.

Formulated to flow into small spaces, use these sealants between fine threads. Threads coated with these sealants can be installed multiple times without recoating. They have low locking strength, so they prevent threads from loosening due to vibration and can be adjusted without tools. They meet NSF/ANSI 61 for use with drinking water.

These sealants have high locking strength, so they work in demanding applications, such as securing mounting studs in motor housings. They also withstand applications with large temperature swings.

Heat cure sealant requires heat of at least 212° F to harden. Above 300° F, the sealant hardens in about 15 minutes. For temperatures below 300° F, it may take up to 4 hours to harden. It requires both heat and a hand tool to unthread.

1500° F max. temp. sealants are for use on cement-lined pipe joints prior to welding. The heat from the welding torch helps them begin to harden.

Sealants that cannot be sold to the listed regions are restricted due to VOC (Volatile Organic Compounds) regulations.

Made of PTFE, this tape has a slippery surface that keeps threads from binding to make parts easy to assemble.

PTFE tape with graphite creates a better seal between threads than plain PTFE tape, which helps prevent fluid and gas leaks. The graphite attaches to the PTFE, so this tape does not emit harmful VOCs.

This tape has a higher density than standard tape for a better seal between threads. Made of PTFE, it has a slippery surface that keeps threads from binding to make parts easy to assemble.

Use color to identify water, gas, and chemical connections. This tape has a higher density than standard tape for a better seal between threads. Made of PTFE, it has a slippery surface that keeps threads from binding to make parts easy to assemble.

Green tape is often used for oxygen.

Orange and yellow tape is commonly used to indicate fuel and gas.

Red tape is often used for water.

This tape is thicker to prevent seizing and galling associated with stainless steel threaded connections. It’s also good for use with other metals. This tape has a higher density than standard tape for a better seal between threads. Made of PTFE, it has a slippery surface that keeps threads from binding to make parts easy to assemble.

With 10% copper flake content, this tape matches the color of copper, brass, and bronze threads for a seamless finish. It’s made of PTFE, so it has a slippery surface to keep threads from binding. This tape has a higher density than standard tape for a better seal between threads.