Combine with a machine key to transmit torque to gears, sprockets, and other power transmission components.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure. They have a flat surface area that allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

Thread these shafts into a tapped hole to support idler sprockets and pulleys in tensioning applications. They have a retaining-ring groove, retaining ring, and spacers to position your component and hold it in place.

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.

Internal threads allow you to mount these shafts onto threaded studs and fasteners, no shaft supports needed.

A shoulder near the end of the shaft allows for easy positioning of housings, shaft supports, and collars.

Designed for use with right-hand, internally threaded rod ends, these rods have right-hand threads on both ends. Use them for remote valve operators, throttle controllers, shifting mechanisms, and virtually any push/pull assembly.

Comparable to Grade 8 steel, these threaded rods have a tensile strength of 150,000 psi, making them about 25% stronger than medium-strength steel rods.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion.

About half the strength of medium-strength steel threaded rods, use these for light duty hanging, mounting, and fastening.

18-8 stainless steel threaded rods have good chemical resistance.

Grade B8 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges. They have good chemical resistance.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion.

These hardened 316 stainless steel threaded rods are 40% stronger than standard Grade B8M threaded rods. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

Made from nylon 6/6, these threaded rods resist oil, grease, and solvents. They’re nonconductive, making them good for use around sensitive electrical components.

Unlike metal rods, these threaded rods will not warp at extreme temperatures, making them ideal for heat treating and furnace fixtures.

PTFE threaded rods withstand temperatures up to 250° F and resist oil, grease, detergents, and most mineral acids. They're the lowest friction plastic threaded rods we offer, so they thread on smoothly.

Brass threaded rods are corrosion resistant in wet environments, electrically conductive, and nonmagnetic.

Bronze threaded rods are stronger and more resistant to salt water than brass rods.

Titanium threaded rods have a high strength-to-weight ratio and are resistant to acids and salt water.

A hex drive on one end allows these rods to be turned with a hex key for ease of installation.

18-8 stainless steel studs have good chemical resistance and may be mildly magnetic. Also known as hanger bolts, use them to hang, mount, and fasten parts to wood structures.

These studs are also known as hanger bolts—use them to hang, mount, and fasten parts to wood structures.

A hollow center allows these studs to be used as an axle, a vent, or a passageway for wiring.

Attach a ball knob to one of these shafts to create custom handles for operating machinery.