Keep your hand away from the material being cut.

The handles are angled 90° from the blade so you can cut material from directly above tight spaces.

Snip tighter curves in smaller spaces than standard high-force cutters.

Prevent waste from flying up as you work. A double blade makes two cuts to create a 7/64"-wide step that peels back, leaving little distortion and smooth edges.

Also known as bulldog snips, these have long handles and short blades for cutting through thick sheet metal with less effort than standard sheet metal cutters.

Replace blades as they wear. These cutters are also known as tinners' snips.

Made from aluminum bronze, the blade and handle on these cutters inhibit sparking and are FM approved. Use them for straight cuts.

Loosen a few screws to swap dull blades with new ones. These cutters have offset handles to keep your hands clear of the metal being cut.

Use to cut patterns in flat material with minimal material loss and less effort compared to manual cutters.

Minimize material loss and edge distortion with these scissor-like cutters that cut metal up to 1/64" thick.

These nibblers punch small pieces out of material to create an almost burr-free cut with no material distortion.

Convert your drill into a sheet metal cutter to make quick, low-effort cuts without a separate power tool.

Make long, straight cuts around your facility—these cutters have a 12" blade and are light enough to move from bench top to bench top.

Move these lightweight cutters wherever you need to make clean, straight cuts through metal.

Turn your workpiece while cutting to create curves and complex shapes.

Leave clean cut edges in a variety of pliable materials.

Make clean, fast cuts in thin metal and plastic when you use one of these saws with an impact driver. The body widens at the top to prevent the saw from pushing through your workpiece.

The carbide teeth on these steel saws cut aluminum, brass, bronze, steel, and plastic sheets and last up to twice as long as high-speed steel teeth.

Attach these saws to your portable drill to cut a range of large diameter hole sizes in sheet metal.

Lower cutting depths than standard hole saws make these saws less likely to rip or tear while making smooth, burr-free cuts in sheets.

For extra leverage to cut through Kevlar, metal, and plastics, these scissors have long handles and short blades.

These small scissors have narrow, sharp tips for fine cutting and trimming.

Prevent snags and injury with the rounded points on these small scissors.

Insulated handles protect against shock from accidental contact with live electrical circuits. These scissors are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Protect sensitive equipment from harmful static discharges while cutting and stripping wire.

Make clean cuts through duct tape and other sticky materials.