McMaster-Carr logo
    Filter by
    DFARS Specialty Metals
    Head Weight
    Overall Length
    Length
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    4 Products

    Dent Pullers

    Image of Product. Front orientation. Dent Pullers.
    Pull dents out of sheet metal panels.
    Overall
    Lg.
    Shaft Thread
    Size
    Includes
    Each
    22"1/2"-20
    		Nosepiece, L-Shaped Puller with Two Screws, Door Edge Tool with Two Nuts0000000000000

    Slide Sledge Hammers

    Strike work in tight spaces where standard hammers don't have room to swing. The steel face on these hammers is hard enough to demolish material and drive pins, punches, and masonry drills. To use, pull back the slide bar and forcefully push the bar forward into the hammer's steel chamber. This drives the face into the workpiece for a powerful strike. All have a ribbed grip for slip resistance.
    Press-Fit Steel Face
    Image of ProductInUse. Shown with 7/8" Dia. Face. Front orientation. Contains Border. Hammers. Slide Sledge Hammers .
    Image of ProductInUse. Front orientation. Contains Border. Hammers. Slide Sledge Hammers .
    Image of Product. Front orientation. Hammers. Slide Sledge Hammers .

    Shown with 7/8"

    Dia. Face

    Head Wt.,
    lb.
    Face
    Dia.
    Overall
    Lg.
    Handle
    Replaceable
    Includes
    Each
    Steel Handle—Ribbed Grip
    142"30"NoCarrying Bag00000000000000
    212"46"NoCarrying Bag0000000000000
     
    Hammer Faces
    7/8" Dia. Push-On Steel Face—7/8" diameter faces allow for more precise strikes than the included 2" face and are good for driving small pins.
    Each
    7/8" Dia. Push-On Steel Face00000000000000
    back to top