The head tilts, rotates, and locks in place to hold work at an angle.

Set includes four vises with different opening sizes to grip a wide range of wire, rod, and drill-bit diameters without switching tools. The hollow body lets long workpieces pass completely through, so there's no length limit on the material you can hold. Turn the collar to close the collet around the material for a secure, centered grip. Well suited to detail work like deburring, polishing, and hand drilling.

The most accurate bench centers you can find. Our centers help you inspect shafts and other cylindrical parts for the tiniest irregularities that could cause wobbles or vibrations. Machined in the U.S., the head and tailstock are precision ground in pairs for exact alignment between the two centers.

Inserting and removing shafts takes seconds. The tailstock slides and locks them in place with the twist of a handle. Unlike V-blocks, these centers hold shafts by their endpoints to check if they are perfectly centered and round with no runout. If you find wobbles that need more machining, you can pop shafts back into the center to take new measurements without realigning your setup.

Clamp thin materials and in tight spaces. Squeeze the handles to open the clamp; release and the spring holds it tightly in place. They have an all-metal construction that makes them good for holding parts while soldering.

Clamps with a hole on the end can be secured to your workholder’s arm, so your hands are free for soldering, gluing, and assembling.