From cookware to chemical-processing equipment, 304 stainless steel is a good all-around choice for a wide range of applications.

When compared to standard 304 stainless steel, this material can be machined faster with less wear on cutting tools. It's also called Prodec and Project 70+.

This wire bounces back after bending. It’s often used to construct springs and wire rope.

Bend this wire and it will stay put. It’s frequently used as tying wire and locking wire.

Widely used for fabricating fittings and fasteners, 303 stainless steel machines quickly without sticking to cutting tools.

Able to withstand repeated stress and wear, 301 stainless steel has the strength required for applications such as springs and fasteners.

One side of these sheets has a brushed finish with grain lines running in one direction to mask fingerprints.

The addition of molybdenum gives 316 stainless steel excellent corrosion resistance. Use it in a variety of marine and chemical-processing applications.

This material machines faster with less wear on cutting tools than standard 316 stainless steel. It's also called Prodec and Project 70+.

Bend this wire and it will stay in place. It's widely used as tying and locking wire.

These rods have been passivated for enhanced corrosion resistance.

2205 stainless steel resists cracking even when faced with a combination of tensile stress, corrosive chemicals, and heat. Also known as duplex stainless steel, it has twice the strength of 316 stainless steel. Use it for high-pressure applications in caustic environments.

The width and thickness are oversized for finishing to your exact requirements.

One of the hardest types of stainless steel after heat treating, 440C offers excellent wear and abrasion resistance. It's often used for bearings, valves, and knife blades.

These balls are hardened for increased wear and abrasion resistance.

Often used for fasteners and valves, 410 stainless steel withstands wear caused by abrasion.

One of the most machinable types of stainless steel available, 416 contains sulfur for fast machining without clogging cutting tools. It's used for gears, screws, and shafts.

Precision ground to a tight diameter tolerance, these rods are all set for turning applications in a lathe.

This material is hardened for increased wear resistance over standard 420 stainless steel.

Suitable for making molds, 420 stainless steel is a hard, wear-resistant material that can be finely polished to a very smooth surface.

With a higher chromium content than 15-5 PH stainless steel, this high-strength 17-4 PH offers better corrosion resistance. It is also known as 630 stainless steel.

Each piece is precision ground to offer tighter tolerances than standard 17-4 PH stainless steel.

Also known as Project 70+, this material machines faster with less wear on cutting tools than standard 17-4 PH stainless steel.

As the most formable of all the PH-grade materials, 17-7 PH stainless steel is widely used in the aerospace industry for intricate parts. When hardened, this material strengthens to make it resist distortion.

The titanium content of 321 stainless steel preserves corrosion resistance around weld points.

Cut this stock into custom shapes to fit your application.