Made of chemical-resistant nylon, these collars are suitable for washdown applications.

Customize the bore of these collars to precisely fit your shaft.

With larger clamping screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Internal ball bearings allow you to slide a collar onto your shaft in one direction and then automatically lock the collar in place in the opposite direction.

One side of these collars locks down like a standard one-piece shaft collar; the other has a flush face that's flat to 0.0005", which lets you mount the collars on a shaft next to precision bearings, sprockets, and gears.

Formed to offset the weight of the clamping screw, these collars won't wobble or vibrate when shafts are spinning—even at high speeds.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Use a wrench to rotate your drive shaft without marring or gouging the shaft.

Although these collars fit inch-sized shafts, they have a metric OD and width for use with metric equipment.

Offering the benefits of a two-piece collar in a one-piece design, these collars swing open for positioning then close anywhere on your shaft.

Secure items to either side of these collars—each half has a flat end with a tapped hole

Two tapped holes on the face of these collars allow you to fasten them to gears, pulleys, and sprockets.

To install, slide these one-piece collars onto the end of your shaft.

To install, thread these one-piece collars onto the end of your shaft.

Install these two-piece collars square shafts.

Slide these one-piece collars onto the end of your shaft to create an end-stop for linear components.

Often paired with spring lock washers to strengthen their hold, these retaining nuts—also known as shaft nuts—keep vibration from shifting bearings, bushings, pulleys, and gears on your threaded shaft or spindle.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

These threaded handles take the place of a set screw, allowing you to move set screw shaft collars without additional tools—useful for when the collar serves as a stroke limiter or mounting clamp.

To install, slide these one-piece collars onto the end of your shaft.

Half the weight of steel, this aluminum framing resists corrosion in wet environments.

Install these threaded collars on a metric lead screw to separate and position components, or use them as an end stop to limit travel.