A spring plus serrated grooves that grip the lip of the channel provide a more secure hold than standard strut channel nuts.

In addition to serrated grooves for gripping the lip of the channel, these nuts have wings for easy positioning.

There's no need for additional fasteners with these nuts—they combine a strut channel nut with a spring and a threaded stud.

Insert these nuts into the long open side of strut channel and twist to secure. A built-in washer enables one-handed installation.

Connect two channels to create a stacked channel.

Quickly attach these nuts by twisting them closed at any point along a threaded rod.

Add hardware to strut channel without having to hold the washer in place or reach inside the channel.

Notches on these washers grip the channel to keep them in place.

Designed to wrap around the sides of strut channel, these brackets provide a stronger hold than other strut channel brackets.

These brackets have narrow slots compatible with quick-connect clamps for securing pipe and conduit on the channel side of struts without screws or tools.

Provide a stable, nonmarring base for strut channel legs.

Create continuous runs of channel without corners.

Run cable and tubing in the tightest spaces with channel that is one-quarter the height and one-half the width of regular strut channel.

This welded, one-piece strut channel combines two strut channels side-to-side.

Slide the strut channel into the tube for telescoping length adjustments.

Brackets mount on the outside of strut channel to allow trolley movement.

For quick mounting of components, these hangers snap into strut channels for a strong hold and easy repositioning.

Position two strut channels at a 30° to 60° angle, then tighten the bolt to secure.

Cover rough ends of strut channel.

Create a four-sided raceway for cable, or give a more finished look to strut channel structures.

Route pipe, tubing, and conduit across strut channel.

Even when these clamps are installed side by side, the clamping screws remain accessible. Use them to route pipe, tubing, and conduit across strut channel.

For areas with low clearance, these clamps have the mounting fastener to the side of the material, rather than on top.

Slide these clamps into strut channel and snap closed for quick installation with no tools required. They are noncorrosive, nonconductive nylon.

Adjust supports to the exact height you need to route pipe, conduit, and tubing through strut-mount routing clamps and hangers.

These plastic hangers prevent corrosion caused by metal-to-metal contact. Push them closed for a more secure hold on material than loop hangers.