Prevent accidental actuation—these toggle switches must be pulled up before they can switch a circuit.

The built-in contact block in these switches extends behind the panel half the depth of most other 22 mm switches, saving valuable space.

More durable than standard metal switches, these can handle tough, repetitive use.

Immediately cut power with a single push.

These aluminum switches are rated NEMA 4, NEMA 13, and IP66 for protection from washdowns and oil/coolant spraying.

Rated NEMA 4, 13, and IP66, these metal switches are protected from washdowns and oil/coolant spraying. Install them in 30 mm dia. cutouts.

Choose an actuator and contact block to make your own 30 mm switch.

Choose an actuator and contact block to make your own 16 mm switch.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

When the pedal is pressed, the built-in potentiometer adjusts the resistance to vary the speed for motor drives.

These 16 mm switches require a key to turn circuits on or off, limiting access to sensitive equipment.

Immediately cut power by pulling the cable.

Stack these slim switches together, or fit them into tight spaces. They're rated IP67 for protection from temporary submersion.

Shorter and thinner than other safety limit switches, these are sized to fit tight spaces.

Often used with machine guards, these switches mount to a door frame.

Assemble your own motor starter by combining a switch and a thermal overload element.

The traditional pressure switch. These power equipment, activate controls or alarms, or kick-off other actions when they reach a set pressure.

Built with an explosionproof enclosure to meet NEMA 7 and 9 standards for hazardous locations, these switches were tested and verified by UL and CSA for use where explosive liquids, dust, and gas are present.

Often built into pumps and hydraulic systems with limited space, these compact switches power equipment, activate controls, and signal alarms when they reach a set vacuum.

Detect the difference in pressure between two points. For instance, these switches can indicate a filter is clogged in a pump or cooling system.

These switches are CSA certified for hazardous locations.

Designed for use in areas where flammable substances are present, these switches are CSA certified for hazardous locations.

Safe to use where flammable gases and combustible dust may be present, these switches activate or deactivate when your flow reaches a factory-set level. All are UL listed for hazardous environments.