McMaster-Carr logo
    Filter by
    Number of Terminals per Circuit
    Mounting Location
    For Wire Gauge
    Industrial Info Compare
    Grounding
    System of Measurement
    Width
    Attribute Image
    DIN Rail Trade Size
    DIN Rail Height
    CSA File Number
    DFARS Specialty Metals
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    Flammability Rating
    Manufacturer
    Manufacturer Model Number
    Maximum Temperature
    Minimum Temperature
    U.S.–Mexico–Canada Agreement (USMCA) Qualifying
    Industrial Info Snippet
    UL File Number
    Wire Entry Location
    For Maximum Screwdriver Size
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    5 Products

    Quick-Connect Modular DIN-Rail Mount Terminal Blocks

    Image of System. Front orientation. Contains Annotated. Terminal Blocks. Quick-Connect Modular DIN-Rail Mount Terminal Blocks.
    Pop wire in and out of these terminal blocks without adjusting a screw for faster installation. Once clamped in place, the wire will stay put when vibrated, bent, or pulled.
    Mix and match these terminal blocks to get the exact number of circuits you need in a single setup. Add blocks for thermocouples, fuses, and grounding wire as needed. The blocks clip side by side onto DIN rail in control panels, creating tidy rows of circuits that you can identify and access on the spot.
    Ground Terminal Blocks with Lever- and Spring-Clamp Terminals
    Image of Product. Front orientation. Terminal Blocks. Quick-Connect Modular DIN-Rail Mount Terminal Blocks, Ground Terminal Blocks with Lever- and Spring-Clamp Terminals.
    Connect grounding wire to DIN rail so fault currents can safely flow to ground. These terminal blocks should only be used for grounding circuits.
    Best when you need to quickly change out field device connections. Use the built-in lever to lift the clamp, then close the lever down onto the inserted wire—no tools required.
    Covers—Snap onto the exposed side of a terminal block to prevent accidental contact with a live wire.
    End Stops—Mount at the end of a group of terminal blocks so they don't slide when vibrated or bumped.
    Adjacent Jumpers—Metal poles create an electrical connection between adjacent terminal blocks, so you can connect multiple components with a single wire. Blocks must be the same width for the jumpers to fit.
    Terminal Blocks
    Covers
    End Stops
    Adjacent Jumpers
    Each
    No. of
    Circuits
    No. of Terminals
    per Circuit
    For Wire
    Ga.
    Wd.,
    mm
    Ht.,
    mm
    Color
    For DIN Rail
    Trade Size
    1-9
    10-Up
    Each
    Each
    Insulation
    Each
    11 (Lever Clamp)
    1 (Spring Clamp)    		22 to 125.263.8Green/Yellow34036N1300000000004036N201000009473T14400000Insulated4036N30100000
     
    Markers
    Image of Product. Front orientation. Terminal Block Markers. Blank.

    Blank

    Label your terminal block connections so you can identify them at a glance.
    For Terminal Block Wd., mm
    Markers
    per Card
    Color
    Each
    Blank
    5.2, 6.2, 7.5, 10, 12100White4036N40100000
     
    back to top