With a durable bronze body, these float valves can be used with water and hydraulic fluid.

Couplings are metal, which has better durability than plastic cam-and-groove hose couplings. Also known as dry disconnects and double shut-off couplings, they have a shut-off valve in the plug and the socket for minimal fluid loss when disconnecting your hose line.

Use these couplings at pressures up to 10,000 psi. The plug and socket thread together to form a stronger connection than other quick-disconnect couplings. They are compatible with High-Pressure Thread-Lock-shape plugs and sockets.

Use these couplings at pressures up to 5,000 psi. They consist of a plug and socket that connect and disconnect quickly. Use them if you need frequent access to a line. They are compatible with International Standard ISO B-shape plugs and sockets.

Distribute air or fluid to multiple locations from a single supply source with these manifolds. They are also known as headers.

Designed for ultra-clean environments, these manifolds are cleaned, dried, and vacuum sealed in plastic to prevent dirt and moisture from contaminating the inside. Use them to distribute air or fluid to multiple locations from a single supply source. Also known as headers.

When you’re short on vertical space, these manifolds are a good fit—they have outlets on the side instead of on top, so they have a lower profile than rectangular manifolds. Use them to distribute air or fluid to five locations from a single supply source.

With outlets on the side instead of on top, these manifolds have a lower profile than rectangular manifolds and fit well in cramped spaces. Use them to distribute air or fluid to three locations from a single supply source.

Use these junction blocks to organize and separate multiple lines in your system. They have threaded holes that allow air or fluid to flow straight through the block.

Start and stop flow with a quarter turn of the handle. Also known as ball valves.

Adjust the flow rate as needed.

Set your flow rate and then adjust it as necessary; these valves maintain flow rate despite pressure changes in the system.

Also known as check valves, these open to allow flow in one direction and close when flow stops or reverses.

Direct flow with an electronic signal.

NFPA valve-mounting blocks have standardized valve mounting patterns to keep hydraulic lines compact and organized.

Push or pull the toggle handle to control flow.

Also known as check valves, these open to allow flow in one direction and close when flow stops or reverses.

Turn the knob to gradually adjust the amount of flow.

To set the pressure, unscrew the cap and turn the adjusting screw.