The holes are already punched in these strips for convenient installation.

Sized to fit short openings.

These strips are ribbed to hide scratches and wear; cut them to length with shears or a utility knife and punch holes for hanging.

Cut these strips to the length you need for hanging in freezer doorways or other cold environments.

Replace worn strips or create a custom door with these individual strips. They completely block light to maintain darkness and privacy.

Cut these strips to the length you need to hang doors for data centers and other areas where static build-up could harm sensitive electronics.

Cut these partially light-blocking strips to the length you need and punch holes for hanging.

Allow personnel and vehicles to move freely through doorways while keeping heated or cooled air in and dirt, dust, and debris out.

Completely block light to maintain darkness and privacy, while allowing traffic to flow freely.

Use these doors in data centers and other areas where static build-up could harm sensitive electronics.

Swap out damaged mounting plates or make custom strip doors by combining a mounting plate with door strips.

Curtains are clear so workers can see and be seen.

Shield workers while allowing them to see and be seen.

Combine straight and curved sections to build a hanging one- to four-sided curtain partition.

Cut with scissors to create custom curtains—they have grommets and are ready to hang.

Hinges allow you to fold these panels into the desired configuration while the clear screens let workers see and be seen.

The carbon fibers on one side of these curtains ground electrical charges to eliminate static.

Typically used for separating work areas such as wash bays, these curtains have a clear center section that allows you to see in as well as out.