Each set includes six grips for pulling one or more cables through conduit.

Flexible enough for pulling wire through multiple bends, this round, stainless steel tape is stiff enough to push through tough runs without backing up.

Safer to use around energized equipment than other types of fish tape, this fiberglass tape is also round, making it more flexible than flat and oval tape to pull wire through multiple bends.

The single loop can handle up to six 10-ga. bare wires at once.

Pull wire and cable while maintaining tension until the line can be permanently anchored. Use these clamps with stranded bare steel wire and cable.

Use a blower or vacuum to insert this lightweight threading line into conduit or raceway, and attach it to your pulling rope to guide the rope.

Use the handheld control to move loads horizontally.

One-piece gears provide more durability than the riveted gears of other hand winches. These winches move loads more gradually than standard hand winches. They take longer to wind but require less effort.

Turn the crank to move material horizontally. These winches wind faster than precise-positioning winches.

Tackle frequent lifting jobs with these rugged winches—their one-piece machined gears stand up to daily use.

These winches are stainless steel for corrosion resistance. Their one-piece machined gears stand up to daily use.

These winches are designed for occasional use.

These winches operate longer than standard electric winches.

These winches operate longer and require shorter breaks than standard air-powered winches.

These versatile pullers give you the capacity of a winch, and have a thick, rugged frame for long life. The wire rope on the pullers is stronger than rope and webbing but not as bulky as chain.

Extra-long handles enable access to hard-to-reach areas. Also known as lineman’s and combination pliers, use these tools to pull, bend, and cut wire.

Deep serrations provide the firm grip necessary for pulling rebar tie wire, and the hook-shaped handle end keeps your hand from slipping off. Also known ironworkers’ pliers, these tools also bend and cut wire.

Made of aluminum-bronze that is FM approved, these pliers satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Use them to pull, bend, and cut wire.

Avoid the potential for an arc flash or short circuit that can occur when using conventional insulated tools with metal components. Completely metal-free, these pliers are plastic with ceramic cutting blades. They are tested to 1,000 volts to meet IEC 60900 and ASTM F1505. Use to pull, bend, and cut wire.

Choose a stainless steel tool for environments where moisture and other contaminants are present. These pliers resist corrosion that can hinder joint movement, but the jaws will wear more quickly than a steel tool. Use them to pull, bend, and cut wire.

An insulated handle protects against accidental contact with live electrical circuits. These picks are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

The assorted tools in these sets are used to hold, separate, and position wire, springs, and other small parts.

The handles of these assorted picks have a magnet at the end to pick up small steel objects. Use to hold and position wire, springs, and other small parts.

Hold, separate, and position small parts with one tool. These sets include assorted picks with a different tip at each end.

Sets include a handle and an assortment of tips for holding and positioning wire, springs, and other small parts.

Avoid nicking or scratching sensitive components. Also known as spudgers, these picks are good for adjusting small wires or separating press-fit plastic components.

Position circuit board components without solder sticking to these picks.

The assorted picks in these sets are used to install and position tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

Install and position tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

Similar to dental instruments, these needle-sharp picks are suitable for work around delicate circuits and components.