Seal out dust and moisture to protect splices, terminals, and other electrical connectors. These covers are lined with a sticky gel that encapsulates the electrical connector. The seal created by the gel helps them meet IP08 standards—use them in junction boxes and outlets exposed to high humidity, rain, and splashing water. Unlike potting compounds, you don't need to mix or pour the gel before you install these covers.

If you have to expand or repair a circuit, you can open these covers and use the wires again. However, once you open the cover and remove the gel, you’ll need a new electrical connector and cover.

A gel filler seals out water to keep your wires completely dry and conductive. No need to strip your wire—insert insulated wires into the splice, then squeeze the button with a crimper or pliers until it clicks. The splice bites through the insulation, so you don't take extra time or risk nicks and cuts from a wire stripper. Snap splices together to create the exact setup you need.

Connect two components with different wire sizes, such as an air compressor and its control panel. Also known as step-down splices, these splices join a larger wire and a smaller wire end to end. The larger and smaller openings are color coded so you don't have to measure and mark them yourself. You can snap splices together to create the exact setup you need.

A gel filler seals out water to keep your wires completely dry and conductive. No need to strip your wire—insert insulated wires into the splice, then squeeze the button with a crimper or pair of pliers until it clicks. The splice bites through the insulation, so you don't take extra time or risk nicks and cuts from a wire stripper.